Wikk Wireless TRABEST915ALP4K User manual

4 CHANNELS TRANSMITTER
TRABEST915ALP4K
Please read this manual carefully before
installing the product.
CONTENTS
1. TRANSMITTER OVERVIEW
1A - General information
1B - Technical specifications
1C - Main components
2. NUMBERING
3. PROGRAMMING
4. OPERATION
5. BATTERY ACCESS
6. TROUBLESHOOTING
1A - General information
The Wikk Wireless - TRABEST915ALP4K transmitter is a key chain style
mini transmitter operating at 915 MHz. It has been designed for the
control of automatic closing systems and anti-burglar systems, thanks to
its very high security coding system Rolling Code.
The code sent by the transmitter changes at each activation, avoiding any
scanning and copying risk. A special algorithm allows to keep synchro-
nized transmitter and receiver.
The 23A battery of the transmitter have a shelf life of about 24 months.
The product fully complies with Part 15 of FCC Regulations.

Operating frequency:
Number of keys:
Battery:
Battery life:
Security Code:
Number combinations:
Operating temperature:
Overall dimensions:
Weight (with battery):
915 MHz
4
12V 23A Alkaline
18 - 24 months
Rolling Code
2exp256
23°F - +131°F (-5°C - +55°C)
2.46’’ x 1.26’’ x 0.39’’ (62.4 x 32 x 10 mm)
0.98 oz. (28 gr.)
1C - Main components
Hidden
key
Keyring
holder
Key 1
Red LED
Key 2
Key 3 Key 4
Fig. 2.

2 - NUMBERING
Each transmitter is manufactured and sold with a different factory-set
serial number.
3 - PROGRAMMING
The transmitter must be programmed into your system memory. Your
own installer or reseller will provide you the necessary instructions for
your system. NOTE: Hidden key is used to remove individual transmitters
from a group of installed transmitters. See receiver manual for details.
4 - OPERATION
A- Firmly depress the button until the red LED illuminates.
B- After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps
A and B or consult section 6 ( Troubleshooting) of this manual.
5 - BATTERY ACCESS
To access the battery, remove the front plastic cover with a screwdriver,
see Fig. 2. Slide out the old battery and replace them with the new ones
[23A] respecting the polarity.
NOTE: Please dispose of the batteries properly according to local laws and
regulations.Test proper battery installation by verifying that the red
LED illuminates when the button is pushed.
6 - TROUBLESHOOTING
PROBLEM SOLUTION
The system does not receive the
transmitter signal.
The transmitter LED will not light
Replace the transmitter
batteries
The system does not receive the
transmitter signal.
The transmitter LED is ON
Check to verify the transmitter is
programmed into your sistem
The operating range is reduced Replace the transmitter
batteries

Wikk Wireless - Type: TRABEST915ALP4K
FCC ID: SU7BEST915ALP4K
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
The warranty period of the 915 transmitters is 60 months, beginning from
the manufacturing date of the transmitter. During this period, if the
product does not operate correctly, due to a defective component, the
product will be repaired or replaced at the sole discretion of the
manufacturer.
The warranty does not extend to the transmitter case which can be
damaged by conditions outside the control of the manufacturer or to
battery life.
NOTICE
WARRANTY
approved by the manufacturer could void the manufacturer’s warranty
Any changes or modifications to this equipment not expressly approved
and the user’s authority to operate this product.