Q5X RefMic User manual

DOCID-M-010-5.0
RM
QT-5100R Quick Start Guide
Next Steps
Have quesons?
We’re listening.
| www.Q5X.com | inf[email protected] | 519-675-6999 |
| www.Q5X.com | inf[email protected] | 519-675-6999 |
Check you included hardware
against the quickstart guide.
Visit www.Q5X.com/support
Register the warranty.
Download digital manuals and
addional resources.
Q5X Support
Scan here to visit our online
support and get access to FAQ,
rmware updates, warranty
registraon, and more.

Quick Start Guide RMQT-5100R
This Quick Start Guide is an overview. Users are asked
to review the enre manual for detailed instrucons
Included Hardware:
• Carrying pouch.
• RefMic transmier (QT-5100R)
• Micro USB charging cable
Users Also Need:
• Q5X Gateway (remote control)
• Handheld MicCommander (QG-H2) or
• Network Gateway (QG-N3)
• Analog receiver
• Microphone (1-pin Lemo connector)
:
Bring the transmier out of storage mode (minimal
baery draw) and into standby mode (detectable but the
UHF radio is o) using either method below:
• Hold the ON/OFF buon unl the status LED changes
from ashing rapidly to slowly, or
• Plug and unplug a powered micro USB charging cable
into the side of the transmier.
• Connect the 1-pin Lemo microphone
Prepare the Gateway remote control (H2 or N3):
• Install the antenna on the top. (NEVER power the
unit without the antenna in place.)
• Power the Gateway as instructed in its manuals.
• Turn on the unit by pressing the power buon.
Pair the BeltMic and Gateway remote control:
• The screen on the Gateway displays the serial
number of paired transmiers.
• Press the <MENU> buon to either scan for
transmiers or add the serial number found on the
PlayerMic antenna.
Adjust:
• Set the funcons in the two transmier menus of the
Gateway. Screen one includes frequency, power On/
O, baery level, mic mute/live and mic gain.
• Screen two includes: transmier name, group, RF
power, 2.4GHz channel, storage and reboot.
:
8 hours @ 50 mw
Dimensions:
RefMic: 99mm x 42mm x 9.4mm
Hardware Diagram:
Key:
1. 2.4 G antenna: For the RCAS control channel.
2. Audio input: Connects to a waterproof
microphone with a 6-pin Lemo connector.
3. UHF antenna: For RF signal transmission.
4. Serial number: The unique number for RCAS ID
and control is on the back of the AquaMic.
5. N/A
6. Status: See manual for details on LED
paerns and colours.
7. Charge: Red = charging, green = charged
and ashing red/green = error.
8. Charging port: AquaMic charges through the
same connector as the audio input using the
charge dongle.
9. On: There is no manual power
control buon on the AquaMic to maintain the
waterproof seal.
10. Belt clip holes: Allows vercal and horizontal
placement.
11. Switch: Mutes and unmutes the transmier.
2
10
11
108
10
1
3
4
10
9
7
6
User Tips:
When using the RefMic,it is
suggested that a strain relief
method be used to ensure that
there is no direct pulling force
on the microphone connector
during use or during removal.
One method is to loop the
microphone cable back and
tape the connector to the edge
of the transmier.