Williams-Sonoma HAMPSTEAD BED QUEEN & KING User manual

Page 1of 4
ASSEMBLY INSTRUCTION FOR HAMPSTEAD BED
QUEEN & KING
IMPORTANT SAFETY INSTRUCTION :
Please read all instructions carefully before assembling.
For your safety, assembly by two or more adults is strongly recommended.
Keep instructions for future use.
Use only vendor supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural
integrity of the item.
PART INCLUDED BOX.1 :
(1) Headboard (A)
(1) Footboard (B)
(4) Finials (C)
(4) Feet (D)
HARDWARE ENCLOSED BOX. 2 :
A
B
D
C
E
F
G
H
PART INCLUDED BOX.2 :
(2) Side rails (E)
(1) Center rail (F)
(1) Center leg (G)
(5) Slats (H)
TOOL REQUIREMENT :
Screwdriver (Not included)

Page 2of 4
ASSEMBLY INSTRUCTIONS :
1. Lay headboard (A)/footboard (B) down on a scratch free or carpeted surface. Attach the finials (C) and the feet
(D) to the headboard (A)/footboard (B) by inserting the bolts into the inserts on the headboard/footboard. Hand
tighten until snug (Do not over tighten) as shown in fig. 1, illustration. 1 & 2.
2. Carefully turn the head board and foot board upright. Insert threaded rods (I) into the inserts in headboard posts
(A) and footboard posts (B) as shown fig. 2 in illustration. 3.
3. Attach the side rails (E) by inserting threaded rods (I) on the posts of the headboard and footboard into the holes
on the side rails (E) as shown fig. 3.
4. Place curved washers (J), flat washers (M), spring washers (L) and nuts (K) onto the threaded rods (I). Tighten
with wrench (N) as shown in illustration. 4.
Illustration. 1 attach the finials
Illustration. 2 attach the feet
Fig. 1
Fig. 2
Fig. 3
A
D
B
D
C
Illustration. 3 Insert threaded
rod
Illustration. 4 attach side rail to HB & FB

Page 3of 4
5. Attach the center leg (G) to the center rail (F) by inserting the bolt into the insert on the bottom of the center rail
(F), hand tighten until snug (Do not over tighten) as shown in illustration. 5.
6. Attach the center rail (F) to the headboard (A) and footboard (B) by sliding it onto the bed fitting as shown in fig.
4, illustration. 6.
7. Lay slats (H) in place over center rail (F) and side rail lips. Attach by inserting the Phillips screws (O) through
pre-drilled holes and tightening with a screwdriver (not included).
Illustration. 5 attach center leg to center rail
Illustration. 7.Install slat
Fig. 5
Illustration. 6 attach center rail to HB & FB
Fig. 4

Page 4of 4
8. Tighten all connections.
9. If the floor is uneven, adjust the recessed levelers found on the bottom of Center Leg.
CARE INSTRUCTION :
Dust often using a clean, soft, dry and lint-free cloth.
Blot spills immediately and wipe with a clean, damp, cloth.
We do not recommend the use of chemical cleansers, abrasives or furniture polish on our lacquered finish.
Hardware may loosen over time. Periodically check to make sure all connections are tight.
Re-tighten if necessary.
For questions or assistance, call 877.812.6235
Turn Leveler Counter
Clockwise to increase height.
Turn Leveler Clockwise to
decrease height.