WilTec 51253 User manual

© by WilTec Wildanger Technik GmbH Seite 4
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Operation Manual
ARTICEL 51253
Universal Bender
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities please contact us.

© by WilTec Wildanger Technik GmbH Seite 5
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
The information contained in this document is subject to change without prior notice. No part of this
document can be copied or duplicated in another form without the prior written consent of WilTec Wil-
danger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in this
user manual or the connection diagram.
Although WilTec Wildanger Technik GmbH hasmade every effort to make sure that this user manual is
complete, accurate and updated, errors cannot always be avoided. In the event of problems with this
user manual please complete and send this form back to us.
FAX-notification (+++49 2403 55592-15),
from: ________________________________________
Name: ________________
Firm:_____________________
Tel/Fax:__________________
I would like to report the following mistakes:
___________________________________________________________________
Customer Service WilTec Wildanger Technik GmbH
e-mail: [e-mail]
Tel:++ [phone]
Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Use only a damp cloth for cleaning. Avoid using cleaning agents and make sure that noliquid enters the
electrical part of the pump.
The electric part of the device contains no parts that can be inspected or serviced by the user. Leave
the maintenance, adjustment and repair to qualified technical personnel. In case of unauthorised inter-
vention the 2-year warranty is no longer valid! Keep these operation instructions safe.

© by WilTec Wildanger Technik GmbH Seite 6
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
1. Main Features:
Easy and precise operation
Bending angle up to 120°
Extremely high precision of bending within the bending range.
Wide supporing face ensuring safe and reliable operation. Bending angle of various radius by chang-
ing and/or turning around die plate.
Using bending eccentric block instead of bracket
2. Specifications:
Cold bending
UB
-
70
UB
-
100
flat steel 70 x 6 mm 100 x 5 mm
Square steel 16 x 16 mm 16 x 16 mm
Round steel 18 mm 18 mm
Angle steel 60 x 8 mm 60x 8 mm
Hot bending
Flat steel 70 x 15 mm 100 x 15 mm
Square steel 22 x 22 mm 22 x 22 mm
Round steel 22 mm 22 mm
Angle steel 70 x 15 mm 100 x 12mm
Universal Bender
1. Limit lever 4. Bending die plate
2. Die plate (fillet radius 10/15)
5. Die plate of diamond section
3. Die plate (fillet radius 20/25) 6. Bending eccentric seat