Windsor Chariot 3 iScrub 26 User manual

WINDSOR
MAINTENANCE
86372430
Chariot 3 iSCrub 26
01)
Drain and rinse recovery
and solution tanks. Vent
the recovery lid for stor-
age.
03) Inspect solution lter and
clean as needed.
05)
Remove and inspect pad or
brushes to clean and replace
as necessary.
04)
Clean squeegee assembly
and inspect the blades. If
the squeegee is damaged or
worn, ip the blade or replace
06)
Take a clean rag and wipe
down the exterior of the
machine and vent tank lid
for storage.
02)
Clean and rinse recovery
tank
07) Plug the batteries back
into the charger and
maintain if necessary.

WINDSOR
MAINTENANCE
00000000
WINDSOR
OPERATION
86372430
Chariot 3 iSCrub 26
01)
Unplug the batteries from
the charger and plug the
batteries into the machine.
05) Chose operation mode. Clockwise
starting at 1 o’clock: Eco-2, Normal,
Heavy, Vacuum only, Water & Agita-
tion only, Transport-1, Transport-2,
Eco-1
04)
Put the key into the ignition
and turn the machine on.
02)
Fill solution tank with water and
measured chemicals. If equipped with
chemical metering ll it with desired
chemical. Make sure brushes and or
pads are installed.
06)
Select direction (forward or
reverse).
03)
Make sure that the solution
tank cap and recovery lid are
closed properly and make sure
latch is secured.
07)
Step onto platform and press
green pedal to move.

WINDSOR
MAINTENANCE
00000000
WINDSOR
OPERATION
86372430
08)
Overlap 2-3” on every pass.
09)
IN CASE OF EMERGENCY:
press the red button to stop
the machine.
Chariot 3 iSCrub 26