Winegard RMFLDM4 User manual

1
RV DIGITAL SATELLITE SYSTEM
with Digital Elevation Sensor
Models RM-DM46/DM00, RM-DM04, RMFLDM4
U.S. PATENT NO. 5,532,710
Made in U.S.A.
Winegard Company • 3000 Kirkwood St. • Burlington, IA 52601-2000
319/754-0600 • FAX [phone] • www.winegard.com
Printed in U.S.A. © Winegard Company 2002 2451069 Rev. 8/02
WINEGARD
®
OWNER’S MANUAL
INSTALLATION INSTRUCTIONS

2
OPERATION
STEP 1. Step outside your vehicle and, using a compass, determine which direction is
North. (Standing in or near vehicle can give you an incorrect reading.) The more accurately
you determine North, the easier it will be to find the satellite(s).
FIGURE 1
Directional Dial
Elevating Crank
Directional Handle
Pointer
Rotation Clamp
Directional
Handle
Step 2. Using satellite receiver, determine correct elevation for your location. See your receiver manual for
details on how to obtain setup information.
Step 3. Press button on Winegard Digital Display Wall plate. If antenna is in travel position the display will
show LL for Low Limit; HL for High Limit, will appear when dish is in up position.
Step 4. Crank elevation handle to raise antenna. Stop cranking when readout displays correct elevation for
your location.
Step 5. Rotate antenna VERY SLOWLY until correct satellite signal is acquired. NOTE: Rotate 3° and then
stop. DO NOT rotate continuously, even if you are rotating slowly. If you notice the elevation angle has
changed, it could be due to the following reasons:
1. RV is not parked level.
2. Antenna system is mounted to a slightly sloped RV roof. (This is not a problem. When you have
rotated the antenna so it is facing in approximatly the right azimuth [compass direction], simply
adjust to correct elevation and continue searching for signal.)
Special Notes: When you have detected the satellite signal, adjust the antenna up/down and left/right for
strongest signal your receiver displays. Due to variations in receivers and installation methods, you may find
the elevation numbers, after peaking on the strongest signal, no longer match what the receiver
recommended. This is normal. The elevation sensor should always get you close enough to pick up a signal
to peak on. If display turns off while you’re searching, just push button for another minute of operation. After
a little practice, most people find the signal in 30 to 50 seconds.
Trouble Shooting
• If digital display reads EE, check wiring and
connection. If these are done incorrectly, it will affect
operation.
•Rotateantenna
VERY SLOWLY untilcorrectsatellite
signal is acquired.
Replacement Parts
For replacement parts, contact Winegard Company.
Customer Service. Hours are 7:00 a.m. to 5:00 p.m.,
Monday - Thursday, and 7:00 a.m. to 4:00 p.m. Friday,
Central Time. Call toll-free 1-800-288-8094. Credit
card only, $5.00 minimum order.
Red Screw