Dimensions in parentheses are in
millimeters unless otherwise specified.4
WOLF WARMING DRAWER
DRAWER FRONT OPTIONS
IMPORTANT NOTE:
Model WWD30 must be
installed with a Wolf stainless steel or
integrated drawer front.
Classic Stainless Steel
WWDFRONT/S
Platinum Stainless Steel
WWDFRONT/P
Carbon Stainless Steel
WWDFRONT/B
Integrated Drawer Front
WWDFRONT/I
(accepts wood panel)
Drawer fronts are ordered and shipped as
sales accessories and include additional
installation instructions. Stainless steel drawer
fronts include a matching tubular handle.
The integrated drawer front accepts a custom
wood panel and handle to be provided by the
homeowner.Optional stainless steel tubular
handles in classic, platinum and carbon stain-
less finishes are available as sales accessories.
TOOLS AND MATERIALS REQUIRED
Wood screws or other hardware to install
the solid platformor runners that support
the warming drawer
2" (51) x 2" (51) or 2" (51) x 4" (102) lumber
for runners—runners must be able to
support200 lbs (91 kg)
2" (51) x 2" (51) or 2" (51) x 4" (102) lumber
for anti-tip block
Power saw
Level
Drill and 1/16"bit, 1/2"bit also for integrated
drawer front application
Phillips screwdriver
2 wood screws (provided)
Wood cleats for integrated drawer front
application
ACCESSORIES
Optional acces-
sories are available
through your
Wolf dealer. To
obtain local dealer
information, visit
the Locator section
of our website,
wolfappliance.com.
BEFORE YOU START
Proper installation is the responsibility of
the installer. Product failure due to
improper installation is not covered under
the Wolf warranty. Refer to the Warming
Drawer Use & Care Information for
warranty details.
Before you install the warming drawer,
make sure you have the Wolf accessory
drawer front called for in your installation.
IMPORTANT NOTE:
If you are installing
the warming drawer with integrated drawer
front in an inset panel application, make
sure that your cabinetry meets the
minimum 33" (838) width and 25" (635)
depth requirement for this installation.
Check with local utilities for electrical codes
that apply in your area. Local codes vary.
Installation, electrical connections and
grounding must comply with applicable
codes. In the absence of local codes, the
drawer should be installed in accordance
with National Electrical Code ANSI/NFPA
70-1990 or latest edition.
This appliance must be properly grounded.
Refer to Electrical Requirements on
page 12.
Make sureyou have the tools and materials
necessaryfor proper installation.
Warranty service must be performed by a
Wolf authorized service center. Wolf is not
responsible for service required to correct a
faulty installation.
