WolfVision VZ-C6 User manual

Ceiling Visualizer Trim Ring Installation Guide
VZ-C6 Installations – Part 1
VZ-C12 / C32 Installations – Part 2
WolfVision Support
2055 Sugarloaf Circle, Suite 125
Duluth, GA 30097
(877) 873-WOLF
[email protected]

Part 1: This guide is for the installation of the WolfVision VZ-C6 + Trim Ring into tiled ceilings.
1) Determine mounting location of
camera using the WolfVision online
application in the Support Section
of www.wolfvision.com.
2) Determine center of down rod
and/or mount of the camera.
Note: You may need to remove the
tile for this step.
3) Mark the corresponding point on
ceiling tile.
A down rod may be used to ensure
proper installation of the unit
above the suspended ceiling.
It is recommended that the unit be
installed a maximum of 1’’ above
the ceiling tile.

4) Measure ¾ inch to rear of camera
(narrow end). This mark will be the
rear of your cutout.
Note: This is the rear of the
camera.
5) Using the mounting bracket as a
template, align the center of one of
the shorter sides with the rear
cutout mark from step 4 and mark
the outside of the bracket.
Note: Center the opening left to
right under the camera.
6) Using this outline, cut a hole in the
ceiling tile.

7) The tile must be notched on the
center of all four sides to allow for
the screw posts.
8) Join the two halves of the Trim
Ring together using the screws
provided.
9) Reinsert tile into ceiling.

Part 2: This section is for the installation of the WolfVision VZ-C12 / C32 Visualizers + Trim
Ring into tiled ceilings.
1) Determine mounting location of
camera using the WolfVision online
application in the Support Section
of www.wolfvision.com.
Note: All measurements are based
on the mount being centered on
the camera. If you have used the
slots in the camera or mounting
bracket to adjust the alignment of
the image, you must adjust the
measurements accordingly.
2) Transfer the center of your mount
to the corresponding point on the
tile.

3) Measure to the rear of the camera
4 - 7/₈’’ towards the rear of the
camera.
Note: The rear of the camera is the
end toward the audience.
4) Measure 5 - 13/16’’ to the left of the
center mark.
5) The measurement in Step 4 will
need to be transferred towards the
rear of the tile to help with
alignment.
6) Align the Mounting Bracket with
the marks made in Steps 3 and 4
and trace the inside.

7) Using this outline, cut a hole in the
ceiling tile.
8) The tile must be notched on the
center of all four sides to allow for
the screw posts.
9) Join the two halves of the Trim Ring
together using the screws provided.
10) Reinsert into Ceiling.

Dimensions