Woodstock Soapstone Fireview 205 User manual

Model 205 Fireview Rear Heat Shield Installation
Please read all of the instructions before you begin the procedure. Confirm that you have
all the necessary tools and parts required. If you have any questions, technical support is
available toll free at 1-800-866-4344, Monday – Saturday 9:00- 5:00, ET.
Tools Needed:
-7/16” wrench
- 5/32” allen wrench
Materials Needed:
- Fireview rear heat shield Part# W-405 or W-406 (to accommodate an outside air
adapter)
- (2) 1” spacers
- (2) 1 ¼” bolts
The rear heat shield is designed to reduce the required clearance to combustibles behind
the Fireview stove from 30 inches to 18 inches, in a parallel installation, or 12 inches
from the rear corners of the stove to the side walls in a corner installation. Pipe clearances
must be maintained as well, and can be reduced with a separate pipe shield, close
clearance pipe, or appropriate wall shielding. Do not paint the interior of the heat shield;
to be most effective it must remain reflective.
Note: If you are installing the rear heat shield in addition to an outside air adapter, one
bolt and spacer included with the shield will replace the button head bolt that secures the
left side of the adapter to the stove.
1. Make sure the stove is cool.
2. Remove the two outermost button head bolts from the back of the flue collar with the
5/32” allen wrench.

3. Insert the bolts provided through the rear heat shield, through the spacers, and thread
them into the holes in the flue collar. If you are installing an outside air adapter, use
the middle button head bolt to secure the right tab of the adapter to the stove first.
Pass the left bolt through the shield, spacer, left tab for the adapter, and then thread it
into the flue collar. Tighten with the 7/16" wrench.
We need your help! Woodstock Soapstone Co. takes pride in
providing the highest quality products as well as the best customer
service in our industry. We welcome your suggestions and input to
help us achieve these goals. If you have any comments to improve
our products, service, and information provided in these
instructions please contact us at [phone] or
[email protected]. Thank you.
Revised 3/24/2011