Woodstock Soapstone Keystone Parts list manual

Keystone/ Palladian Ash Door Handle Replacement
Please read all of the instructions before you begin the procedure. Confirm
that you have all of the necessary tools and materials. If you have any
questions, technical support is available at 1-800-866-4344, Monday –
Saturday 9:00 – 5:00, ET.
Tools Needed:
- (2) 7/16’ wrench or wrench and socket
- 3/8” wrench
- 3/32” Allen wrench
Materials Needed:
- Ash door handle part #W-237
-¼-20 x 1” bolt
-¼-20 nut
- Wave washer
1. Make sure the stove is cool.
2. Open the ash door and remove the original handle using a 7/16” wrench. It may be
helpful to use a wrench on both the bolt head and nut.
3. Insert the 1/4-20 X 1” bolt up through the tab in the door, through the wave washer
and then thread it into the new handle.

4. Tighten the bolt so that the handle moves with some resistance and then secure it in
place with a 1/4-20 nut. Hold the bolt still using a 7/16” wrench while tightening the
nut so that the tension on the handle is not changed.
5. Be sure the handle moves along with the bolt and nut freely.
6. Close the door on a slip of paper to confirm a good seal. There should be resistance as
the paper is pulled out. To adjust the tension on the ash door, use a 3/8” wrench to
loosen the lock nut on the ash door lock (located on the base of the stove), and a
3/32” allen wrench to manipulate the set screw to increase or decrease the tension on
the handle. Turning the set screw clockwise increases tension; counter-clockwise
decreases tension. Tighten the lock nut when adjustment is complete.
We need your help! Woodstock Soapstone Co. takes pride in
providing the highest quality products as well as the best customer
service in our industry. We welcome your suggestions and input to
help us achieve these goals. If you have any comments to improve
our products, service, and information provided in these
instructions please contact us at [phone] or
[email protected]. Thank you.
Revised 5/5/2011