ASSEMBLY INSTRUCTIONS
MODEL: PL214
2 of 2.
!ATTENTION !
Place all wooden parts on a clean, smooth surface to prevent them from being scratched.
Check to be sure that you have all parts and hardware. Remove all wrapping materials, including staples and packing straps before
you start to assemble. Do not tighten all screws/bolts until all completely assembled. Keep all hardware parts out of reach of children.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
1
Screw Adjustable Glides (5) into Side Panel(A)&(B).
3
2 OF 2
Before assembly, please remove all parts from carton, verifying that you have the correct quantities, and read all the instructions.
INSTRUCTION:
!ATTENTION !
Place all wooden parts on a clean, smooth surface to prevent them from being scratched.
Check to be sure that you have all parts and hardware. Remove all wrapping materials, including staples and packing straps before
you start to assemble. Do not tighten all screws/bolts until all completely assembled. Keep all hardware parts out of reach of children.
If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.
Failure to follow these warnings may result in injury.
MODEL: PL214
C
A
B
Take out Back Panel(B)
to do wiring.Release
Housing counter
clockwise as Shown to
take out Back Panel(B).
Housing
1
Attach Housing Caps to
all Klix Cams by pushing
neck of cap through
center of cam.
3
2
Attach PL213(C) to
PL214 by usingJCBC
Screw & Flat
Washer.
INSTRUCTIONS:
