Socket: S1 S2 S3 S4 S5 S6
Number: 1 2 4 8 16 32
For example: No shortcut block is needed when coding the monitor as No.1;
Shortcut block should be plugged in S1, S2, S3 when coding the monitor as
No.16 (1+2+4+8=15). Shortcut block should be plugged in S3, S4, S5
when coding the monitor as No.29 (4+8+16=28).
Note: All monitors should share the same coding status when they are in the
same house.
5.3 Answering Calls from Door Station:
When there is a call received from the door station (the maximum time of
ring tone is 10s), the image from the Door Station will auto-display on the
screen. If there is no response after 30s, the monitor will return to the stand-by
state. Within 30 seconds, the user can press “ ” button talk with the visitor for
at most 2 minutes' conversation. To release the electric lock for the visitor,
press “ ” button. To end the conversation, press “ ” button, or the system will
shut off automatically in 7s after pressing unlock button.
When the door station is FZH-121C, the door station and monitor ring for
10s. Then, they will return to the stand-by state.
5.4 Calls from Door Phone:
When there is a call received from one of the door phones, other door
phone(s) have been connected, the phone you have picked will return to the
stand-by state after 2s.To answer the call, press “ ” button within 30s(Pick up
the door phone within 10s if the door station is FZH-121C). The max conver-
sation time is 2 minutes. To end the conversation, press “ ” button.
Press “ ” button to end calling.
5.5 Monitor:
There is an impedance match socket in the back side of the Door Phone.
Please do remember to plug in the shortcut block if only one door phone is
used; If more than one Video Door Phones are connected, Please plug in the
shortcut block on the furthest door phone.
When in stand-by state,press “ ”, the screen will show the image of No.1
door station and tenant can intercom with No.1 door station.
Press“ ”again to shut off the screen.Within 10 seconds, tenant press
“ ” again, the screen will show the image of No. 1 door station if there is not
No.2 door station, or show the image of No.2 door station. To end it,
press “ ” again,
The monitor will stop monitoring automatically after 1 minute.
Press “ ” to unlock the visitor when monitoring and return to the state of
monitoring after 7s.
5.6 Volume adjustment:
When in stand-by state, press “ ” for 5s until there hears the ringtone.
Press the unlock button to adjust the volume range form high/medium/low;
Choose the suitable ringtone volume, and without operation after 5s, it will
save the volume and exit the ringtone setting.
5.7 Door phone secondary-unlock:
In any cases, tenant press the secondary-unlock button, the port in the
door phone will export a switch signal to control the door.
