• The use of patch panels, wall plates, cable transmitters, kinks in cables, and
electrical or environmental interference will have an adverse effect on
signal transmission which may limit performance. Steps should be taken to
minimize or remove these factors completely during installation for best
results.
• WyreStorm recommends using pre-terminated RJ45 cables due to the
complexity of these connector types. Using pre-terminated cables will
ensure that these connections are accurate and will not interfere with the
performance of the product.
IMPORTANT! Wiring Guidelines
Wiring and Connections
WyreStorm recommends that all wiring for the installation is run and terminated prior to making connections to the switcher. Read through this section in its
entirety before running or terminating any wires to ensure proper operation and to avoid damaging the equipment.
Copyright © 2022 WyreStorm ProAV Corporation | wyrestorm.com
SYN-TOUCH10 Quickstart Guide | 221210 2 of 2 INT: +44 (0) 1793 230 343 | US: 844.280.WYRE (9973)
Warranty Information
WyreStorm Technologies ProAV Corporation warrants that its products to be free from defects in material and workmanship under normal
use for a period of ve (5) years from the date of purchase. Refer to the Product Warranty page on wyrestorm.com for more details on our
limited product warranty.
Wall Mounting Installation
WyreStorm recommends that this section is read through in its entirety before to ensure proper installation and avoid damaging the equipment.
US Screw
Holes
UK/EU
Screw
Holes
Note: Before installation, make note of the
US and UK/EU screw holes shown in the
graphic above for respective backboxes.
Once the respective backbox has been
installed, use the mounting screws
provided to attach the wall mount to
back box.
To attach the SYN-TOUCH10, slot the
mount key into the keyhole on the back
of the tablet and use one of the provided
M3L8 screws to secure in place
