Xenith X2E+ User manual

X2E+
FIT GUIDE

We design the best protective
gear in football.
FITTING INSTRUCTIONS
Follow these steps to ensure your X2E+ ts properly or go
to Xenith.com/t to view our tting videos and additional
tutorials. Accessories such as Sizing Pads, Comfort Pads,
and Jaw Guards are available to enhance your t.

Slide each buckle along the chin strap
until you can snap the buckle into place
on the outside of the helmet with no
discomfort or slack in the straps.
ADJUST THE LOW
BUCKLES & SECURE
2
1
Unbuckle the straps and place the
helmet on your head so the front edge
rests just above your brow. Then pull
the lower chin straps outward until the
chin cup slides up to meet your chin.
The internal suspension system will
tighten until it feels snug and secure
around your head.
PLACE THE HELMET
ON YOUR HEAD
CROWN COMFORT INSERT
If the helmet sits too high above your
brow, remove the crown comfort insert
located underneath the comfort pads
in the top of the helmet.

Pull the high chin straps upwards so
that the chin cup sits comfortably
under your chin. Repeat Step 2 on the
high straps, snapping them into place
once the helmet is secure and
ts comfortably – again making sure
there’s no slack in the straps.
ADJUST THE HIGH
BUCKLES & SECURE
3
With all four buckles snapped into
place, apply mild force to the
facemask in multiple directions.
If there is excessive movement,
tighten the chin straps and
readjust the buckles until you’ve
achieved a snug, secure t.
CHECK FOR
PROPER FIT
4

Once your helmet is comfortable and
secure, feed the end of the chin strap
through the second slot of each
buckle to lock in the t.
LOCK THE
BUCKLES IN PLACE
5THE COMPLETE GETUP
Get the gear you need to take the eld with condence.
Shop for more protective gear and accessories at Xenith.com.

No helmet can guarantee prevention of serious head or neck injuries which may occur as
a result of playing football, including brain injury from a concussion. This helmet is not
intended to oer any protection from neck injury. To reduce the risk of head or neck injury,
do not use your head to make contact with an opposing player. Keep your head in an upright
position and do not use this helmet to butt, ram or spear any player. Such use is in violation
of football rules and can result in severe head and neck injuries, including but not limited to
concussions, paralysis or death, to you and/or an opponent. You should immediately report
any of the following symptoms to your trainer, doctor, coach and parents: “seeing stars,”
disorientation, confusion, wooziness, dizziness, loss of balance, loss of memory, headache,
neck or spine pain, nausea, vomiting, or any other symptom you believe may be the result
of an impact to the head. If you experience any of the above symptoms, discontinue all
football activities until you have received written medical clearance and all symptoms
have resolved for an extended period of time. Ignoring this warning may lead to additional
and more serious injury, including potentially fatal second impact syndrome. Removal of
any warning label on this helmet will void, as to that helmet, the helmet warranty and any
indemnication or contribution right that may exist. For more information, visit Xenith.com.
XENITH FOOTBALL HELMET WARRANTY
XENITH WARRANTS HELMET SHELLS TO BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF (5) YEARS FROM THE DATE OF SHIPMENT FOR ALL
YOUTH AND VARSITY SHELLS INCLUDING THE ASSEMBLED LINER (INCLUDING THE INTERIOR LINER, ALL SHOCK ABSORBERS, JAW PLATES AND HOOK/LOOP ATTACHMENTS);
COMFORT PADS ARE WARRANTED FOR ONE (1) YEAR ONLY. IF, DURING THE WARRANTY PERIOD, THE HELMET SHELL AND/OR LINER FAIL IN THE COURSE OF NORMAL USE
DUE TO MATERIAL DEFECT, CUSTOMER, (NOT OTHER PARTIES HAVING PHYSICAL POSSESSION OF THE EQUIPMENT) SHALL NOTIFY XENITH AND REQUEST A RETURN
AUTHORIZATION. THE DEFECTIVE UNIT SHALL THEN BE RETURNED TO XENITH’S REPAIR CENTER BY CUSTOMER, FREIGHT PREPAID, WITH A FAILURE REPORT ALONG WITH
THE PLACE AND DATES OF RECONDITIONING. IT WILL EITHER BE REPAIRED OR REPLACED, AT XENITH’S OPTION, AND RETURNED TO CUSTOMER OR ITS DESIGNATE, FREIGHT
PREPAID. DUTIES, TARIFFS AND TRANSPORTATION INSURANCE ASSOCIATED WITH SUCH RETURN SHALL BE CUSTOMER’S RESPONSIBILITY. THE FOREGOING WARRANTY
SHALL NOT APPLY TO DEFECTS RESULTING FROM: 1) IMPROPER OR INADEQUATE MAINTENANCE BY CUSTOMER; OR, 2) UNAUTHORIZED MODIFICATION, MISUSE OR ACCIDENTS.
CUSTOMER MAY REPLACE WORN COMPONENTS (FACEMASKS, FACEMASK CLIPS, SNAP BUCKLES, CHIN STRAPS, CHIN CUPS) WITH ONLY XENITH APPROVED REPLACEMENT
PARTS. CUSTOMER SHALL INFORM USERS THAT XENITH RECOMMENDS: 1) ANNUAL RECONDITIONING OF EACH HELMET BY A XENITH AUTHORIZED RECONDITIONER AND THAT
FAILURE TO DO SO MAY ADVERSELY AFFECT THE PERFORMANCE OF THE HELMET; 2) THAT HELMETS BE RETIRED FROM SERVICE NOT LATER THAN TEN (10) YEARS AFTER
INITIAL USE; AND 3) THAT SHOCK ABSORBERS SHOULD NEVER BE SWAPPED FROM ITS ORIGINAL LOCATION TO ANOTHER WITHIN THE INTERIOR LINER (SEE SHOCK ABSORBER
ALTERATION WARNING BELOW.) THIS WARRANTY SHALL BE VOID AS A RESULT OF ANY OF THE FOLLOWING:
1. REPAIRS OR ALTERATIONS MADE TO A HELMET WHICH MODIFY OR ALTER THE HELMET INCLUDING THE REMOVAL OF ANY WARNING LABELS.
2. USE OF HELMET REPLACEMENT PARTS OTHER THAN XENITH APPROVED REPLACEMENT PARTS.
3. THE APPLICATION OF ANY UNAPPROVED DEVICE OR MATERIAL TO THE HELMET.
4. FAILURE TO USE A XENITH AUTHORIZED HELMET RECONDITIONER. (A LIST OF AUTHORIZED RECONDITIONERS AS OF THE EFFECTIVE DATE IS ATTACHED TO THIS
AGREEMENT; AN UPDATED LIST MAY BE OBTAINED FROM XENITH’S CUSTOMER SERVICE DEPARTMENT OR AT WWW.XENITH.COM.)
5. FAILURE TO RECONDITION THE HELMET AT LEAST ONCE EVERY TWO (2) YEARS.
WARRANTY EXCLUSIONS: EXCEPT AS NOTED, THE FOLLOWING COMPONENTS ARE NOT WARRANTED: CHIN PIECES, LOW AND HIGH CHIN STRAPS, SNAP BUCKLES,
FACEMASKS, FACEMASK CLIPS, AND FASTENING HARDWARE INCLUDING BUT NOT LIMITED TO T-NUTS, SCREWS AND SNAPS. NOTWITHSTANDING THE FOREGOING, XENITH
WARRANTS THE HYBRID STRAP AND CHIN CUP ASSEMBLIES FOR ONE (1) YEAR.
SHOCK ABSORBER ALTERATION WARNING: XENITH USES SEVERAL TYPES OF SHOCK ABSORBERS IN EVERY HELMET. EACH TYPE OF SHOCK ABSORBER IS DESIGNED
DIFFERENTLY AND STRATEGICALLY PLACED IN THE INTERIOR LINER TO ACHIEVE THE DESIRED PERFORMANCE. SHOCK ABSORBERS SHOULD NOT BE INTERCHANGED OR
SWAPPED FROM ONE LOCATION TO ANOTHER. ALTERING THE SHOCK ABSORBER CONFIGURATION COULD RESULT IN ADVERSELY AFFECTING THE PERFORMANCE OF THE
HELMET. XENITH DISCLAIMS ANY RESPONSIBILITY OR LIABILITY RESULTING FROM UNAUTHORIZED ALTERATION OF THE SHOCK ABSORBER CONFIGURATION. YOU MAY ONLY
REPLACE WORN OR DAMAGED JAW AND CROWN SHOCK ABSORBERS WITH IDENTICAL XENITH REPLACEMENT PARTS.
© 2018 Xenith, LLC. All rights reserved. XENITH® and ™are trademarks, service marks, or registered trademarks of Xenith, LLC., in the United States and other countries.
Printed in the USA.

XENITH |We design the best protective gear in football.
@XENITH
@XENITHFOOTBALL
FACEBOOK.COM/XENITH
JOIN #TEAMXENITH
XENITH.COM
XENITH
DETROIT, MI
CUSTOMER SERVICE
[email protected]
866.888.2322