XERO XTI 5.0 User manual

AUSTRALIA HONG KONG MALAYSIA NEW ZEALAND SINGAPORE UAE UNITED KINGDOM UNITED STATES
1. Trough
2. Paver or Concrete
3. Leveling material
4. Brackets for leveling
5. Power feed inlet
123 4 5 6
XTI 5.0 | INGROUND UPLIGHT CASE
1Identify contents
Instruction
Sheet
If more information is required please contact your local representative by going to xerolighting.com/contacts or email us at headoffi[email protected]
INSTALLATION INSTRUCTION
22
22
Install case in suitable location making sure it is level
Maintain width of opening with supplied disposable
brackets - (Make sure the protective film is not removed
until luminaire installation takes place)
2
34
2
52
6
Ensure that the case is installed into a free draining
location with drainage material underneath
Install power feed cables - making sure that the
connections point is in an enclosure
Pave or finish groundworks
For installation of the
XTI | 5.0 Inground Uplight IP67 IK10+
please turn over page
locate the correct
case for each luminaire
2
2
7
Trough
Bracket pre-
attached to trough
disposable brackets
protective film
TOP VIEW
1
2
3
4
6. Drainage material 5
6
7. Drainage hole
7
Perform a drainage
test once case is
installed to ensure that water free drains.
Luminaire must not be immersed in water for more than 30 minutes

AUSTRALIA HONG KONG MALAYSIA NEW ZEALAND SINGAPORE UAE UNITED KINGDOM UNITED STATES
1Identify contents
1 x Instruction
Sheet
If more information is required please contact your local representative by going to
xerolighting.com/contacts or email us at headoffi[email protected]
22
22
Make electrical
connection
3
3 4
22
56
If luminaire has remote drivers****
1. Luminaire
2.
Case
3.
Fastners
4.
5.
Driver
INSTALLATION INSTRUCTION
Power connection
XTI 5.0 | INGROUND UPLIGHT IP67 IK10+
1 x Luminiare
1
2
3
4
5
Locate correct luminaire
with appropriate installed case.
Install luminaire
ensuring the gap
at the end and
between Luminaires
is 1mm.
Fix luminaire with
supplied post torx
fasteners
post torx fasteners
Install drivers in a remote cabinet (not supplied),
ensuring all external connections remain IP rated
Connect electrical cables ensuring
that the cable lengths are all the same
and do not exceed the maximum
rated length
WARNING
Luminaires are NOT site serviceable. Luminaires must be returned for any repair or maintainence.
If luminaire is opened on site the warranty is VOID
6 x Post torx
fasteners