Xerox WorkCentre PE16 User manual

SERVICE
WorkCentre PE16
Manual
WorkCentre PE16 CONTENTS
1. Precautions
2. Reference Information
3. Specifications
4. Summary of product
5. Disassembly and Reassembly
6. Alignment and Adjustments
7. Troubleshooting
8. Exploded Views and Parts List
9. Block Diagram
10. Connection Diagram
071-0871-00

22
2-1
nformation
Service Manual
WorkCentre PE16 July 2003
2. Reference Information
This chapter provides reference information for this service manual consisting of the tool list, a list
of acronyms and abbreviations, andexamples of test patterns.
2.1 Tool for Troubleshooting
The following tools are recommended for perfomance of the troubleshooting functions described in this service manual.
DVM(Digital Volt Meter)
Standard: Indicates more than 3 digits.
1
Tweezers
Standard: For general home use, small
type.
2
Software(Driver) installation CD
ROM
6
Cotton Swab
Standard : For general home use, for
medical service.
4
Cleaning Equipment IPA
(Isopropyl Alcohol) dry cloth or a
liquid neutral detergent.
5
Driver
Standard : "-" type, "+" type (M3 long, M3
short, M2 long, M2 short).
3

5
5
5-1
Disassembly and Reassembly
Service Manual
WorkCentre PE16 July 2003
5. Disassembly and Reassembly
5.1 General Precautions on Disassembly
When you disassemble and reassemble compo-
nents, you must use extreme caution. The close
proximity of cables to moving parts makes proper
routing essential.
If components are removed, any cables disturbed
by the procedure must be restored as close as
possible to their original positions. Before remov-
ing any component from the machine, note the
cable routing that will be affected.
Whenever servicing the machine, you
must perform the following:
1. Check to verify that documents are not stored
in memory.
2. Be sure to remove the toner cartridge before
you disassemble parts.
3. Unplug the power cord.
4. Use a flat and clean surface.
5. Replace only with authorized components.
6. Do not force plastic-material components.
7. Make sure all components are in their proper
position.
8. Observe ESD precautions when handling sensi-
tive electronic components.
Releasing Plastic Latches
Many of the parts are held in place with plastic
latches. The latches break easily; release them
carefully.
To remove such parts, press the hook end of the
latch away from the part to which it is latched.

XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual
XEROX WorkCentre PE16 service manual