7
Start
Place the scale, and using the bubble on the backside for level It.
Press On / Off to turn on the scale. Following a countdown, marked also by the beep, you will see the
software version, the capacity of the scale, and then you enter the measurement mode.
Wait at least 30 minutes to warm up before the first use.
Date and Time settings
Switch on the balance. Keep pressed for 3 seconds for date and time settings menu: “rtc-set”.
First value requested is the year: the display shows “Year **”:
Use the following buttons to modify the blinking value:
set the value,
scroll to the next value
confirm.
Successively are required:
1. Month Month
2. Day Day
3. Hour Hour
4. Minute Min
User Calibration
Each balance is calibrated in the laboratory by technicians using certified sample masses.
Provided with all models there is a sample mass useful to test the functionality of the instrument.
Calibration procedure:
oTurn on the balance and wait at least 30 min. of warmup
oKeep pressed button for 3 seconds,
the display shows first “Cal 0”, “-------“, and then it shows the sample mass [g]
requested for the calibration. *
oPlace the sample mass on the plate.
oDisplay first shows “-------“, than the weight measurement.
Calibration is complete.
* With the button is possible to change this value, choosing one of the allowed for that model (Tab 1)
