XtraLight LWP User manual

LWP LED WALLPACK
IMPORTANT SAFETY INSTRUCTIONS
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE
PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES
RISQUES INHÉRENTS.
1. READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
2. INSTALLATION REQUIRES KNOWLEDGE
OF LED LIGHTING AND ELECTRICAL
SYSTEMS.
3. THE LED LUMINAIRE MUST BE WIRED IN
ACCORDANCE WITH THE NATIONAL
ELECTRICAL CODE AND APPLICABLE
LOCAL CODES.
4. PROPER GROUNDING IS REQUIRED FOR
SAFETY.
5. THIS LED LUMINAIRE MUST BE
INSTALLED PER THE APPLICABLE
INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION
AND OPERATION OF THE PRODUCT. DO
NOT ATTEMPT INSTALLATION IF THIS
CONDITION IS NOT MET. CONTACT A
QUALIFIED ELECTRICIAN.
6. DO NOT USE THIS LUMINAIRE FOR
ANYTHING OTHER THAN ITS INTENDED
USE.
7. DANGER-RISK OF
FIRE OR
ELECTRICAL
SHOCK-
DISCONNECT
POWER BEFORE
BEGINNING
INSTALLATION.

LWP LED WALLPACK
INSTALLATION
THIS LUMINAIRE IS INTENDED FOR SURFACE MOUNT ONLY.
1. Loosen door screws (2 on Med. and Lg.; 1 on Small) and remove the door by swinging open and
lifting up off of hinges. (See Figure 1)
2. On Small LWP only, remove LED plate by loosening 2 screws. (See Figure 2)
Figure 1
Figure 2
LED Plate
screws
Hinges
Door Screw
Bosses
Quick
Disconnects

LWP LED WALLPACK
3. Disconnect the Quick Disconnects and set door (and LED plate on Small) aside.
4. Insert supply wires through all thread and install the mounting plate, gasket and o-ring to standard
junction box, in the order shown below, using the included screws and the appropriate holes. (See
Figures 3 & 4)
5. Remove the center plug from the housing. Mount housing onto the all thread and use the nut
provided to attach the fixture to the wall plate. Be sure to put convex side of nut against housing as
shown below. Use 1-1/16 inch socket wrench to tighten nut. (See Figures 4 & 5)
Figure 3
Figure 5
Mounting
Plate
All thread
Center
Plug
All thread
Wall
Gasket
O
-
ring
Fixture
Housing
Nut
Figure 4

LWP LED WALLPACK
6. Connect supply wires to fixture wires from quick disconnect using wiring diagram. (See Figure 6)
7. On Small LWP only, reinstall the LED plate back into housing and tighten 2 screws.
8. Replace and close the door and tighten the door screws, ensuring that the gasket is in place between
the door and housing.
9. Seal all unused holes, plugs, conduit and threads with weatherproof silicone.
10. Seal around both sides and top of fixture against mounting surface with weatherproof silicone.
WIRING
Universal driver: 120VAC - 277VAC, 50/60HZ.
1. Verify that the electrical power to the Luminaire is in the OFF position.
2. Connect the fixture side Black lead to Line supply lead
3. Connect the fixture side White lead to Neutral supply lead.
4. Connect the fixture side Green lead to Green supply lead.
5. Energize the electrical power and verify proper operation.
Figure 6
IN0009 Rev. 3 03/19/2018