Xyfx 30cc Geebee- R3 User manual

Contact Address：5th Floor,LiDong Technology Building,High-tech Zone, Guilin,China
Email：[e-mail]
www.xyfx-model.com.cn
30cc G eebee- R3 ARF
ASSEMBLY MANUAL
桂 林 鑫 鹰 飞 翔 模 型 有 限 公 司
Guilin XinYing FeiXiang Aircraft Model Co.,Ltd

KIT CONTENTS

P01
Stick the hinges to the rudder firmly with AB glue
P02
Fix the control horn to rudder
P03
Drill a 6mm diameter hole on the bottom of rudder, fix the steel wire to the bottom of rudder with
AB glue

P04
Put someAB glue on the hinges which link with rudder, then stick to the fuselage
P05
Fix the tail landing to fuselage
P06
Assemble control horn, rudder cable, ball link and connecting rod to rudder

P07
Fix rudder servo, rudder cable, ball link and connecting rod as picture
P08
Stick the hinges to the elevator firmly with AB glue
P09
Fix the horn to elevator with self-tapping screws

P10
Put someAB glue on the hinges which link with elevator, then stick to the horizontal tail
P11
Cut the hole on fuselage for elevator servo
P12
Fix the elevator servo as picture

P13
Assembly horizontal tail to fuselage, then measure the same angle for both sides
P14
Fix horizontal screws, rubber loop and washer
P15
Check the horizontal tail and fuselage at correct angle, then fix them with screws

P16
Stick hinges to aileron firmly with AB glue
P17
Put someAB glue to hinges which link with aileron , then stick to the wing
P18
Fix control horn, push rod and servo to the aileron

P19
Cut the film on the wing for landing gear
P20
Check the right or left side landing gear, then assembly it
P21
Put someAB glue into landing gear trail on the wing, then fix the landing steel wire firmly

P22
Fix the landing gear plates as picture
P23
Fix the wheel and wheel adapter as picture
P24
Put the wheel active cover on the wheel pant, then drill hole to fix it on the wheel pant

P25
Drill hole on the wheel pant, then fix it to the wing
P26
Cut the film on the fuselage for wing
P27
Push the wing into fuselage as picture

P28
Fix the two wings to fuselage with two screws one each side
P29
Align mounting template with fire wall and tape in place
P30
Drill engine mounting holes according to the signals on fire wall

P31
Fix the engine to fire wall as picture
P32
Gather the fuel tank parts as picture
P33
Fix the fuel tank as picture

P34
How to drill a hole on the cowling: tape one piece paper on the fuselage and mark the hole
position, then put the cowling on fuselage and align it with the hole, then drill the hole on cowling
P35
Fix the cowling on fuselage with screws
P36
Fix the spinner and propeller onto the engine

P37
Fix the canopy on fuselage with screws as picture
P39
The installation is completed!
ENJOYYOUR FLY!!!
CG as above picture
P38