Yamaha PCY65 User manual

PCY65/65S
OWNER’S MANUAL
■Handling Precautions
•Do not disassemble or alter the product. Doing so may result in damage or deterioration to the product.
• Do not step on or place heavy objects on the product. It may result in damage.
•Do not use or keep the product in places with extremely high temperature (places in direct sunlight,
close to a heater, in a closed car, etc.) or damp (bathroom, outside on a rainy day, etc.). It may result in
deformation, discoloration, stickiness, damage or deterioration.
•To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly.
If the product is soiled or sticky, use a neutral detergent on a cloth then wipe with a damp cloth that has
been wrung out thoroughly to remove any remaining detergent. Do not use benzine, thinner or alcohol
as it may result in discoloration or deformation. Also pay close attention so as not to let the water and
detergent come into contact with the cushions used in the product, it may result in deterioration.
•When connecting or disconnecting the cable, make sure that you hold the plug, not the cable. Also,
never place any heavy objects on the cable and never allow any sharp objects to come into contact
with the cable. Applying excessive force to the cable may result in damage to the cable such as cutting
the wires, etc.
■Inside This Package
Before setup, please make sure that all of the items listed below are present and ac-
counted for. If anything is missing, please contact the dealer from whom you purchased
the unit.
* To customers who purchased a pads set (DTPK95M, etc.), please refer to the
attached “Accessories List”sheet included with each pads set when confirming
package contents.
■Output Level Adjustment
INTRODUCTION
Thank you for purchasing the Yamaha PCY65/65S Cymbal Pad.
The PCY65/65S is designed for use as a cymbal type trigger pad in an electric drum system.
Its unique design allows compact setup and realistic performance. To get the most out of
your PCY65/65S, please read this Owner’s Manual carefully. After reading, please keep this
manual in a safe place for future reference.
Controls the level of the trigger output from the PCY65/65S. Use a small screwdriver, etc. to
rotate the level adjustment knob.
Rotate the knob to the right (+) to increase the output level, or to the left (–) to decrease
output level. The pad's output level should be adjusted in regards to how hard you hit the
pad, to adjust the pad's dynamic range, or to better match the pad to the type of DTX Series
Drum Trigger Module (DTXPRESS/DTX/DTXTREME) you are using.
■Replacing Worn Pads
•After extended use, some of the parts used on the PCY65/65S will wear out or their
quality will deteriorate (pad rubber, connecting jacks, etc.).The life of these parts will vary
depending upon the circumstances under which the PCY65/65S is used.
•Please ask the dealer from whom you purchased the device about replacing worm parts.
Adjusting the Voice Volume
To change the volume of the voice assigned to the PCY65/65S pad, use the [VOICE]
edit mode in the DTX Series Drum Trigger Module. Please refer to the Owner's Manual
that came with your module for more information.
NOTE: When the PCY65/65S is used with a DTX Series Drum Trigger Module, enter the module's Trigger
Edit Mode and set the [PAD Gain] (pad input level) parameter so that the display reads 90-95% when
the pad is struck ff. Refer to the Owner's Manual that came with your module for more information.
Level
Adjustment Screw
: Do not put excessive pressure on the level adjustment knob, it may result in
damage.
保証書
この度はヤマハ・CYMBALPADPCY65/65Sをお買上げ戴きましてありがとうござ
います。本書は、本書記載内容で修理を行なう事をお約束するものです。お買上げの
日から下記期間中に故障が発生した場合は、本書をご提示の上お買上げの販売店ま
たは最寄りのヤマハ電気音響製品サービス拠点に修理をご依頼ください。
1. 正常な使用状態（取扱説明書、本体貼り付けラベルなどの注意書に従った使用状態）で故障した場合には、お買上げの販売店
が無料修理を致します。
2. 保証期間内（6ヶ月間）に故障して無料修理をお受けになる場合は、お買上げの販売店に商品と本書をご持参のうえご依頼くだ
さい。
3. ご贈答品、ご転居後の修理についてお買上げ販売店にご依頼できない場合には、最寄りのヤマハ電気音響製品アフターサー
ビス拠点にお問い合わせください。
4. 保証期間内（6ヶ月間）でも次の場合は有料となります。
(1) 本書のご提示がない場合。
(2) 本書にお買上げの年月日、お客様、お買上げの販売店の記入がない場合、及び本書の字句を書き替えられた場合。
(3) 使用上の誤り、他の機器から受けた障害または不当な修理や改造による故障及び損傷。
(4) お買上げ後の移動、輸送、落下などによる故障及び損傷。
(5) 火災、地震、風水害、落雷、その他の天災地変、公害、塩害、異常電圧などによる故障及び損傷。
(6) 消耗部品の交換。
(7) お客様のご要望により出張修理を行なう場合の出張料金。
5. この保証書は日本国内においてのみ有効です。
ThiswarrantyisvalidonlyinJapan.
6. この保証書は再発行致しませんので大切に保管してください。
※この保証書は本書に示した期間、条件のもとにおいて無料修理をお約束するものです。したがってこの保証書によってお 客
様の法律上の 権利を制限するものではありませんので、保証期間経過後の修理などについてご不明の場合は、お買上げの
販売店、ヤマハ電気音響製品アフターサービス拠点にお問い合わせください。
無償修理規定
ご販売店様へ※印欄は必ずご記入の上お渡しください。
持込修理
品名／品番
保証期間
※お買上げ日
お客様
※
販
売
店
CYMBALPADPCY65/65S  製番
本 体：お買い上げの日から6ヶ月
年 月 日
住 所 〒
お名前 様
電 話 （ ）
印
（ ）
店 名
住 所
電 話
●PCY65S
• PCY65S Main Unit X1
• Stereo Phone Cable X1
Stopper X1Stopper X1
Plug has two black rings
(The monaural type con-
nector has one black ring.)
• Owner’s Manual (this sheet) x1
●PCY65
• PCY65 Main Unit X1

■Part Names ■Connections
Use the supplied stereo phone cable to connect the pad's output jack to the input jack
(RIDE, CRASH, etc.) on the DTX Series Drum Trigger Module (DTXTREME/DTX/
DTXPRESS). Insert the L-shaped plug into the Output Jack on the
underside of the PCY65/65S pad.
The manner in which the PCY65 and PCY65S will function corresponds to the INPUT
numbers on the DTX Series Drum Trigger Module shown in the chart below.
*Make sure you set the module's pad type setting to cymbal. (Refer to the Owner's Manual that
came with your module.)
■Setting Up
First setup the rack system (Yamaha RS70,
etc.) or a commercially available cymbal stand
(Yamaha CS series, etc.) and then attach the
PCY65/65S as shown in the illustration.
Stopper
Cymbal Support
Felt
Wing Nut
1.First, insert the stopper underneath the
cymbal support, and then use a drum key
(optional) to secure.
2.Make sure that the rod on the stopper is
inserted into the hole on the upper por-
tion of the PCY65/65S.
NOTE: The Stopper is used to prevent the cymbal
pad from rotating during performance and
allow setting of the cymbal pad to any angle.
Edge (The PC65S is equipped with a built-in edge switch)
Pad
PCY65SPCY65
Output jack
Level Adjustment Knob
Pad
Printed in Indonesia
WF75890
SPECIAL MESSAGE SECTION
NOTICE: Service charges incurred due to a lack of knowledge relathing to how a function or effect works (when the unit is operating
as designed) are not covered by the manufacturer’s warranty, and are therefore the owners responsibility. Please study this manual
carefuly and consult your dealer before requesting service.
ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. We sincerely
believe that our products and the production methods used to produce them, meet these goals. In keeping with both the letter and the
spirit of the law, we want you to be aware of the following:
Warning: Do not attempt to disassemble.
Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end,
please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, plastics, etc. If your
dealer is unable to assist you, please contact Yamaha directly.
NAME PLATE LOCATIOIN: The name plate is located on the bottom of the product. The model number, serial number are located on
this plate.
You should record the model number, serial number, and the date of purchase in the spaces provided below and retain this manual as
a permanent record of your purchase.
Model : PCY65 Serial No.
Model : PCY65S Serial No.
Purchase Date
PLEASE KEEP THIS MANUAL
■Specifications
Size
Weight
Sensor System
Output Jack
312(W) X 245(D) X 46.5(H) mm
620g
Tr igger Sensor (Piezo) x 1 Tr igger Sensor (Piezo) x 1 /
Edge Switch x 1
Standard Monaural Phone Jack Standard Stereo Phone Jack (stereo)
PCY65 PCY65S
* Improvements may result in a change in the specifications and/or design of the product without notice.
■Troubleshooting
If the following trouble occurs when the PCY65/65S is used, please check the following
points before asking your dealer for assistance.
Also, please refer to the Owner's Manual that came with your DTX Series Drum Trigger
Module (DTXTREME/DTX/DTXPRESS) for more information regarding the problems
described above and any other problems that you may be experiencing.
If a solution can not be found to the problem after consulting the manuals, please contact
the dealer from whom you purchased the product.
●The Choke function doesn't work.
What to check
Problem
Is the pad type for the module Input
to which the PCY65S is connected
set to anything other than cymbal
pad?
The choke function is unavailable if the pad type is set to anything
other than cymbal pad.
Output jack
Insert
●No Sound, Volume is Low
What to check
Problem
Is the PCY65/65S properly connected
to the DTX Series Drum Trigger
Module's input jack using the
supplied stereo phone cable?
Refer to the previous “Connections” section and make sure
that all connections are proper.
Is the Level Adjustment Screw on
the PCY65/65S set too low?
If the Level Adjustment Screw is set too low, the single pro-
duced by the pad will be too low to produce sufficient volume
from the drum trigger module’s tone generator even though
the pad is struck.
Is the module properly connected to
a pair of headphones or an external
audio device such as an amplifier,
speaker, etc.?
Check the connections between the external device and the
position of the power switch and volume level.
Are module settings correct? Check the volume setting of the voice assigned to the input to
which the PCY65/65S is connected (refer to the previous “Ad-
justing the Voice Volume” section) or that the volume level for
the headphones is not set too low, etc.
●： A single voice can be assigned to, and produced by
the pad.
○： Independent voices can be assigned to and produced
by the pad and edge section (Dual Zone; The cup
and pad sections share the same voice).
A choke function (grabbing the edge section stops
the voice being produced by the pad) is also avail-
able.
＊：A mute function (holding the edge section produces
an alternate sound when the pad is hit) is also avail-
able.
NOTE: Make sure a stereo phone cable is used when connecting the PCY65S to the module. The
switch functions described above will not function with a monaural phone cable. (Only the
voice assigned to the pad can be produced.)
Since the PCY65 does not incorporate a edge switch, use of a monaural phone cable is
allowed.
Module
DTXTREME s
DTXTREME
DTXPRESS
DTXPRESS
DTXPRESS
DTX
InputNumber
1〜8
9/10 〜 15/16
1〜8
9/10
1〜8
9/10,11/12
PCY65
●
●
●
●
●
●
PCY65
○＊
●
○
●
○＊
●