Yard Craft Wood Adirondack Swing User manual
ASSEMBLY MANUAL
WOOD
ADIRONDACK SWING
Parts List
Tools Required For e Job
5/32” Hex Key (included)
*NOTE: This Hex Key is used
to tighten all the fasteners
used in the assembly process.
seat
backrest
hardware pack 2 Armrests
2 chain packs
4 armrest
supports
1/2" wrench
4
Place the seat in this position and fasten legs to seat
assembly using two 2 1/4" bolts and the eye bolt.
Fasten arms to arm rest supports by threading two
3" lags into the pre-drilled holes.
Repeat on opposite side.
Thread a 3 1/2" lag into pre-drilled hole. Then
align with pilot hole on backrest. Tighten after both
sides are started.
Step: 2
Step:4
Step: 3
Step:1lock nut
washers
Fasten armrest to back support. On a 3" lag place a
washer then the last link on the chain pack. Thread
through pre-drilled hole on armrest into pilot hole on
backrest. Overtightening can strip out the hole. If this
happens, use a 4" lag(not provided). Repeat on
opposite side.
4
Tighten all bolts at this time.
Remove chain from bag. There will be two "ends" to
the chain. Place one end through the pre-drilled hole
on the armrest.
Fasten center seat support to bottom of backrest
using screw provided.
Step: 6
Step:8
Step: 7
Step: 5
Congratulations! Your swing assembly is now
complete! Your swing should appear like this when
completed.
Fasten to quick link on the eye bolt. Use the other
end to hang your swing at the desired location. On
most applications, the angle of the swing will be
correct, but it can be adjusted using either quick
link. Repeat on opposite side.
