Yard Craft WOOD ADIRONDACK LOVE SEAT User manual

WOOD ADIRONDACK
LOVE SEAT
ASSEMBLY MANUAL

Parts List
5/32” Hex Key
(included)
*NOTE: This Hex Key is used to tighten all the
screws used in the assembly process.
Tools Required For e Job
back assembly
2 armrests
seat assembly
2 legs
hardware pack

4
Fasten armrest to leg using 2" bolt
through pre-drilled hole.Tighten now.
Repeat on opposite side.
Place seat assembly in this position on a
smooth, clean surface. Then fasten one leg
to seat assembly using 1 1/2" bolts through
pre-drilled holes. Only finger tighten now.
Repeat this step on opposite side.
Place assembly in this position.
Step:2
Step:3
Place assembly in this position.
Step:1
Step:4

4
Fasten armrest to center of back
assembly using 2 1/2" lag. Align with
pre-drilled hole. Then repeat on
opposite side. Tighten now.
You are now ready to install the back
assembly.
Fasten at this point using 1 1/2" bolt.
Tighten, then fasten at opposite end
as well.
Step:6
Step:7
Tighten legs now that were finger
tightened on step 1.
Step:5
Step:8

Fasten support on back assembly to
support on seat assembly using 2 1/2"
screws.
Step:9
Congratulations! Your assembly is now
complete. Your love seat should appear
like this when complete.
Step:10