Yema RALLYGRAF PANDA User manual

CHRONOGRAPH WATCHES

AB

DATE-SETTING
To adjust the date, pull the crown to POSITION A. Then simply turn it clockwise until
the desired date appears in the window.
IMPORTANT: Do not make date adjustments when the time on the watch reads
between the hours of 9:00pm and 3:00am. The reason is that although a date makes
its changeover close to midnight, the gears that make that change happen to engage
quite a bit earlier. It takes extra time to disengage completely in the aftermath.
POSITION A

AB

TIME SETTINGPOSITION B
In order to adjust the time, pull out the crown to the last notch. Then turn it in either
direction until the hands indicate the correct time.
IfthecrownispulledtoPOSITION Bwhilethechronographisstarted,thechronograph
hands will continue to move. This is not a malfunction.

CHRONOGRAPH
FUNCTIONS

START/STOP CHRONOGRAPH
RESET CHRONOGRAPH
PUSHER A
PUSHER B
Press button A to start the chronograph. The chronograph hands
will start moving.
Press button A again to stop the chronograph. The chronograph
hands stop to indicate the elapsed time.
The center 1/5 chronograph second hand displays the elapsed
seconds while the 9 O’clock sub-register shows the elapsed
minutes (maximum 60 minutes)
Press button B to reset the chronograph. All the chronograph
hands will be reset to “0” position.
A
B

TACHYMETER
FUNCTION

The bezel on your watch has a tachymeter function used to measure a speed or a
flow rate using the chronograph function. Select the desired unit of measurement
(metre, kilometre, mile, litre, etc.], activate the chronograph and stop it when the
desired unit is reached. The centre seconds hand indicates the number of units per
hour on the tachymeter scale.
In order to ensure the precision of the tachymeter, the unit of measurement must
be exactly reached. In addition, the time of measurement should not exceed 1
minute and should not be less than 9 seconds.

MAINTENANCE
OF YOUR YEMA WATCH