Yema SPEEDGRAF User manual

CHRONOGRAPH WATCHES

BAC

DATE-SETTING
If your YEMA watch is equipped with a date, pull the crown to POSITION B. Then
simply turn it anti-clockwise until the desired date appears in the window.
IMPORTANT: Do not make date adjustments when the time on the watch reads
between the hours of 8:00pm and 2:00am. The reason is that although a date
makes its changeover close to midnight, the gears that make that change happen
to engage quite a bit earlier. It takes extra time to disengage completely in the
aftermath.
POSITION B
POSITION A MANUAL WINDING
Your YEMA watch is equipped with a self-winding mechanical movement, this
means is wound automatically by wrist movements alone. To ensure optimum
winding, wear your watch daily.
Before you first use the watch or if unworned for a long period of time, you will need
to wind it manually by turning it clockwise.

BA C

TIME SETTINGPOSITION C
In order to adjust the time, pull out the crown to the last notch. Then turn it in either
direction until the hands indicate the correct time.
If the crown is pulled to POSITION C while the chronograph is started, the
chronograph hands will continue to move. This is not a malfunction.

CHRONOGRAPH
FUNCTIONS

START/STOP CHRONOGRAPH
RESET CHRONOGRAPH
PUSHER A
PUSHER B
Press PUSHER A to start the chronograph. The chronograph
hands will start moving.
Press PUSHER A again to stop the chronograph. The
chronograph hands stop to indicate the elapsed time.
The center chronograph second hand displays the elapsed
seconds while the 9 O’clock sub-register shows the elapsed
minutes (maximum 30 minutes)
Press PUSHER B to reset the chronograph. All the chronograph
hands will be reset to “0” position.
A
B

MAINTENANCE
OF YOUR YEMA WATCH

• Ensure that the crown is perfectly screwed down after winding up the movement and/or setting
the time and the date. Once the crown is fully screwed down against the case, your YEMA watch
is guaranteed waterproof.
• Avoid activities that may expose your watch movement to shocks.
• Never use chemicals to clean your YEMA watch. Use a microfibre cloth and wash the metal,
rubber, fabric bracelets and waterproof cases from time to time with a soft brush and soapy
water. We recommend that you do not use abrasive or corrosive products (solvents, detergents,
perfume, etc.).
• Always rinse your watch with fresh water after it’s been exposed to salt water.
A YEMA watch requires little maintenance. However, some precautions
must be taken to ensure the durability of your YEMA:

MODELS:
CALIBER: SEIKO NE86 POWER RESERVE: 45H
SPEEDGRAF | YSPEE2019-AAS

YEMA.COM
YEMA WATCHES reserves the right to modify the
models illustrated in this publication at any time.