Yetong YET-112 User manual

Remark: User cards can be added or deleted continuously. If you have set a new Manager
Add Card, you can’t recover recently deleted all user cards.
NO Mark Color Function Remark
1 Unused Pink Unused
2 Unused Pink Blue Unused
3 DO Green WG DATA0
4 D1 White WG DATA1
5 Unused Grey Unused
6 OPEN Yellow Exit Button
7 D_IN Brown Door Contact
8 12V+ Red Power+
9 GND Black Power-
10 NO Blue Relay NO output
11 COM Purple Relay Com output
12 NC Orange Relay NC output
1.Technical parameters
NO Item Value
1
Operating voltage DC 12V±10%
2 Static current ≤10mA
3 Dimensions U200:135mm×58mm×22mm
4 Weight U200:500g;
5 Ambient temperature -40℃ - 60℃
6
Relative humidity 10%—90%
7 Storage 2000users
8
Card type (alternative) EM(ID) card(IC card for options)
9 Card reading distance 1－15CM
WIFI One-doorAccess Controller
Introduction
This access control use newest microprocessors and high-speed long-life EEPROM
non-volatile memory, card reader and mobile phone APP controller integrated design, with
a simple circuit, low power consumption, simple operation, stable and reliable and
outstanding advantages.
Support opening door by mobile APP,APP can open/close door timing, countdown
open the door ; APP can manage numerous access control, managers can share
countless users and other functions, APP using WAN connection.
User Manual V2.5
4. Installations Guide:
4.1 Wire Connection :
4.2 Diagram
2.How to set Manager Card
Step1、Turn off power and connect bin 2&3 of INI (J2) to restore factory settings
( users will not be deleted, if added)。
Step2、Turn on power and green light. now read two empty cards ,first one as
Manager Add Card and Second one as Manager Delete Card
Step3、Turn off power, disconnect bin2&3 and connect bin 1&2 of NOR。
Step4、Turn on power again.
3. How to use Manager Card – MAC&MDC
To add a card user in standby mode: read MAC read new cards read MAC
To delete a card user in standby mode: read MDC read registered cards read MDC
To delete all users in standby mode: read MDC read MAC read MDC
To Recover recently deleted all user cards: read MAC read MDC read MAC

5. Download and install our EWeLink APP in Android:
5.1 Download APP----->>Install APP----->>EWeLink proceed----->>Open
EWelink----->>Register----->>LOGIN----->>Add device----->>InputWIFI
name and password----->>Pairing Device(the matching button on the PCB
board of U200-APP) ----->> Pairing Success
5.2 Can using setting to change device name;
Share function can share device to other person.
Timer function can set up open/close door timing
Countdown function can set up open/close door delay
5.3 The Release Button is door open/close ON/OFF,the share person also
see the door status.
(Note: APP supports Android 4.0 above version, ios 8.0 above version)