YOODA CAMELEO 1Rw User manual

CAMELEO_1Rw | CAMELEO_2Rw
In order to fully explore available functions of CAMELEO series please take a moment and read this manual before using the device.
CAMELEO transmitters are compatible with all YOODA brand devices.
Illustrations (from the top):
Fig. 1. 2-channel CAMELEO wall-mounted remote control, white (CAMELEO_2Rw)
Fig. 1. Replacable frames for CAMELEO wall-mounted remotes (colours form left:
pearl, choco, titan, beige, metalic)
General information
Detailed description
www.sukcesgroup.pl
1. Control:
can control single motor,
or a group of up to 20 motors on each channel
2. Range:
200 meters outdoor,
35 meters indoor
3. Battery:
2 x CR2032
4. Power supply:
3 V
5. Dimensions:
80 x 80 x 14 mm
6. Transmitting power:
10 mW
7. Operating temperature:
from 0°C to 50°C
8. Protection degree:
IP 30
Radio receiver range is a variable value and can differ from declared values depending on conditions in which device
operates. Possible sources of changes in range are building construction, interference caused by other radio transmitters
etc.
To access P2 programming button, batteries and mounting holes remove front frame.
Single-channel transmitter
(front)
Single-channel transmitter
(view after removing front frame)
UP button
STOP button
DOWN button
P2 programming button
+

1. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
2. Batteries should be changed when LED diode stops flashing when channel is being changed or receiving device stops
reacting to commands.
3. When placing the battery ensure that polarity is correct.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
CAMELEO_1Rw | CAMELEO_2Rw
In order to fully explore available functions of CAMELEO series please take a moment and read this manual before using the device.
CAMELEO transmitters are compatible with all YOODA brand devices.
Detailed description
Programming remotes with R-type motors
www.sukcesgroup.pl
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming first transmitter will result in deleting all previously programmed transmitter.
Turn on power supply
or press microswitch
(for 2 sec.)
when power is on.
Motor will make a sound.
Roller shutter will make
an up / down move.
Motor will
make a sound.
Press programming
button (P2)
on the remote.
or
Roller shutter will
make an up / down
move as the motor will
make few sounds.
Motor will
make a sound.
Press programming
button (P2) on the
remote.
Press
UP button
on the remote.
2-channel transmitter
(front)
2-channel transmitter
(view after removing front frame)
UP button
1st channel 2nd channel
STOP button
DOWN button
UP button
STOP button
DOWN button
P2 programming button
(2nd channel)
P2 programming button
(1st channel)
+