YOSensi YO 360 User manual

1. Unscrew the device: remove 4 screws from the enclosure.
Quick Installation Guide
360
4 1
6. Statuses, colours and behaviour of the diode (if the device is properly
connected):
Device is working correctly (power and memory) - single GREEN ash
Device is working incorrectly (power and memory) - single RED ash
Connecng to LoRaWAN - ashing BLUE
LoRaWAN frame sent - single WHITE ash
Conrmaon from server aer receiving the frame - single WHITE ash
Frame failed to conrm within specied meout - single RED ash
LoRaWAN Disconnected - ashing BLUE
Connecng to BLE - ashing BLUE
RGBW diode
Version 2 - November 2021

4. Match the PCB (marked components) to the enclosure according to
the diagram. Place the PCB in the enclosure with the baery basket
facing up.
2 3
C
A
B
D
3. Assemble the device. The order of the elements is important:
Place the PCB (B) at the top of the enclosure (A)
Then insert the seal (C)
Fit the boom part of the enclosure (D)
2. Place CR2450 3 V baery in the device according to the polarity.
5. The device is on. Screw it back together.