Zagg rugged messenger case Setup guide

Online Manual
Durable Case with Snap-on Screen Protector
rugged messenger
™
case

Getting Started
1Inserting Your Device:
First, insert
your device at an angle so that the
power button, volume control, camera
hole, and the opening for your charging
cable fit into their respective cutouts on
the Rugged Messenger Case. Next, set
the rest of your iPad into the case and
press it in. Press all around your iPad to
make sure the tablet is secure.
2Attaching the Snap-On PET Screen:
Place the PET screen on the device as it
sits inside the Rugged Messenger Case.
Align the screen with the sides of the case
and then snap it into place on the case.
2

4Adjusting the Viewing Angle: Your
Rugged Messenger Case features built-in
magnets that work together with the
built-in cover to create three different
viewing angles. To adjust the viewing
angle of your iPad, simply slide the
built-in kickstand up or down along the
Rugged Messenger Case until you feel
the magnets connect; there are three
different sets of magnets built into the
case to create multiple viewing angles.
3Using the Stand:
Fold the cover/built-in
stand back, away from the case and lay it
flat while holding the iPad at an angle
perpendicular to it. Bend at the first fold
of the cover to create a triangle. Press
the remaining narrow strip of the built-in
stand against the back of the case. The
strip is magnetized and will click into
place against the back of the case. The
magnets will hold the case in place at that
angle until you choose to move it.
ZAGG and Rugged Messenger Case are trademarks of ZAGG Intellectual Property Holding Co., Inc.
iPad is a trademark of Apple Inc., registered in the U.S. and other countries.
Adjustable
Magnetic
Stand
Built-in
Magnets