Zaor Vision WS User manual

Vision WS

Unpack the parts carefully (do not use a cutter on the foam wrapping, as you might damage
the surface) and set up so that you can see the part numbers clearly. In the big box you should
find a small cardboard box with all the screws and bolts for assembly.
Here you have an exploded view of the whole desk and how it is supposed to come together.
We use high quality furniture assembly components from renowned EU manufacturers.
Please, never use force. These parts should come together easily, in case of doubt check the
manual again or contact support.
The assembly of your desk uses special kits.
Here's how to use them
1) On the piece with the threaded
insert(s) , put in the system bolt(s)
and tighten making sure to align the
hole in the system bolt at a 90º angle.
Please note that the system bolt may have
a little slack in this position, which is fine!
2) Ensure that the hole in the bolt
aligns with the opening in the other
piece to be able to put in the safety
screw.
3) In each hole in the second piece, put
in a cone shaped safety screw and
tighten with a cross (philipps)
screw driver - without forcing.
The 2 parts will now be safely
attached.
Thanks for choosing a piece of furniture from Zaor. Before you can enjoy
the use of it you need to build it. We tried to put all the explanations
necessary for a safe build, when in doubt please get in touch or check out
our Youtube channel where we are putting more and more assembly
videos to help you with this important task. Enjoy!
General technique for putting together Zaor desks
A
D
C
B
EF
G
H
I
J

Push wooden dowels type W in the appropriate holes
E
F
G
H
STEP 1

STEP 2
Use screws Type A (x6)
A
B
I

STEP 3 STEP 4
Use screws Type A (x6)
Join panels E and F. Attach,
using the system bolts that you
mount on the threaded inserts in
panel F. Adjust so they are
pointing such that holes can be
seen when inserted into panel E
(no need to tighten them). Use
the small slanted screws to
tighten the connection between
the two panels. Proceed likewise
for the other connections.
D
C
F
E

STEP 5 STEP 6
H
I
F
EG
D
C

STEP 7 STEP 8
H
I
D
C

STEP 9
Type W
Wooden dowels m6x35 mm Rack rail
Rack rail screws Rack units screws
PACKING LIST:
x20 Type B x12 Type R x4
Type Rs
x6 Type Ru
x24
TOOLS:
35 mm
Assembly Kits
x20
Suggested
*
*
INSTRUCTION FOR USE AND CLEANING
- clean with a soft cloth, slightly humid or specific products
for wood or lacquer;
- avoid the use of abrasive cleaners.
Rack bolt screws
Type Rb
x3
Hex wrench
Type H
x1
STEP 10
Type Rb Type Rs
J