Zephyr ALU-E63 Operating and maintenance manual

www.zephyronline.com
RANGE HOOD - Installation and use instructions
ENGLISH........................................3
FRANÇAIS...................................35
ALU-E43
ALU-E63

- 2 -

- 3 -
Table of contents
Safety Instructions................................................Page 4 - 5
List of Materials.................................................... Page 6
Ducting Calculation Sheet.................................... Page 7
Hood Specifications..............................................Page 8 - 9
Wiring Diagram.....................................................Page 10 - 11
Cleaning and Maintenance...................................Page 12
Remote Control.................................................... Page 13
Hood Controls...................................................... Page 14 - 15
Installation
Remote Blower................................................Page 16
Internal Blower................................................ Page 17 - 20 - 21 - 22
Preparation......................................................Page 18 - 19
Wiring.............................................................. Page 23 - 25
Range Hood................................................... Page 26
Wiring Internal Blower..................................... Page 26
Wiring External and In-Line Blower................ Page 27
Non-Ducted Recirculation Kit.......................... Page 29
Mesh Filters.....................................................Page 30
List of Parts & Accessories...................................Page 31
Warranty...............................................................Page 32

- 4 -
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact
the manufacturer at the address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service panel and lock service panel to
prevent power from being switched on accidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warning device, such as a tag, to the service
panel.
3. Installation work and electrical wiring must be done by a qualified person(s) in accordance with
all applicable codes and standards, including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting of gases through the flue
(chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment
manufacturer’s guidelines and safety standards such as those published by the National Fire
Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden
utilities.
6. Ducted fans must always be vented to the outdoors.
7. To reduce the risk of fire, use only metal ductwork.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the
risk of electrical shock by providing an escape wire for the electric current.
WARNING - Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not completely understood, or if
doubt exists as to whether the appliance is properly grounded.
WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when flambeing food (i.e. Crepes Suzette,
Cherries Jubilee, Peppercorn Beef Flambe’).
3. Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or fil-
ter.
4. Use proper pan size. Always use cookware appropriate for the size of the surface element.
5. Keep fan, filters and grease laden surface clean.
6. Use high range setting on range only when necessary. Heat oil slowly on low to medium set-
ting.
7. Don’t leave range unattended when cooking.
8. Always use cookware and utensils appropriate for the type and amount of food being prepared.
!
INTENDED FOR DOMESTIC COOKING ONLY
!

- 5 -
WARNING
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE
FIRE, OBSERVE THE FOLLOWING:*
1. SMOTHER FLAMES with a close- tting lid, cookie sheet, or metal tray, then turn o the burner.
BE CAREFUL TO PREVENT BURNS. If the ames do not go out immediately, EVACUATE
AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels - violent steam explosion will re-
sult.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you already know how to operate it.
B. The re is small and contained in the area where it started.
C. The re department is being called.
D. You can ght the re with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by NFPA.
!
CAUTION
1. For indoor use only.
2. To reduce risk of re and to properly exhaust air, be sure to duct air outside. Do not vent exhaust
air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
3. Take care when using cleaning agents or detergents.
4. Avoid using food products that produce ames under the Range Hood.
5. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and
vapors.
6. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray,
construction dust, etc. o power unit.
7. Your hood motor has a thermal overload which will automatically shut o the motor if it becomes
overheated. The motor will restart when it cools down. If the motor continues to shut o and
restart, have the hood serviced.
8. For best capture of cooking impurities, the bottom of the hood should be a minimum of 36” and
a maximum of 72” above the cooking surface.
9. Two installers are recommended because of the large size and weight of this hood.
10. This power pack is equipped with a RF receiver (optional remote control sold separately).
Changes or modi cations not expressly approved by the party responsible for compliance
could void the user’s authority to operate this product. The remote control generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instruc-tions, may cause harmful interference to radio communications.
11. Please read specication label on product for further information and requirements.
12. To reduce risk of re and electric shock, install this range hood only with Internal Blower Model
CBI-290A, CBI-600A or PBI-1100A, Exterior Blower Model CBE-1000 or In-Line Blower Model
PBN-1000A, (manufactured by PacicKitchen). Other blowers cannot be substituited. (Blower
sold separately).

- 6 -
LIST OF MATERIALS
- Zephyr blower sold separately
- Non-ducted recirculating kit sold separately
Electrical system Box
Connection Air Outlet Assembly
(External motor and 2 motors)
Remote Blower Box Cover
Remote Blower Box
Box Cover (box marked “120
VAC Input”)
Box marked “120 VAC Input” Led
Mesh Filter
Hardware Packet
Remote Blower Wiring
Extension
Remote Blower
Wiring Harness
Driver Box
(only model ALU-E63)

- 7 -
DUCTING CALCULATION SHEET
Maximum Duct Length:
For satisfactory air movement, the total duct length
should not exceed 100 equivalent feet.

- 8 -
HOOD SPECIFICATIONS
ALU-E43

- 9 -
HOOD SPECIFICATIONS
ALU-E63

- 10 -
WIRING DIAGRAM
ALU-E43