Zephyr Monsoon II AK9340AS Installation guide
LIUHTXLUHGE\ORFDOFRGHV
Light Bulb Removal
Suction Cup (1)
M4 x 6mm (4)
Wire Caps (3) #8 x 1/2” (12)
RF Remote Control (1) Remote Holder (1)
Duct pieces To t a l
Equivalent number
length x used =
3-1/ 4” x 10”
Rect.,
straight
1 Ft. x ( ) = Ft.
7”-10” Round,
straight
1 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.900
elbow
15 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.450
elbow
9 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.900
flat elbow
24 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.
wall cap
with damper
30 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.to
6” round
transition
5 Ft. x ( ) = Ft.
3-1/ 4” x 10”
Rect.to
6” round
transition
900elbow
20 Ft. x ( ) = Ft.
6” Round,
900elbow
15 Ft. x ( ) = Ft.
6” Round,
450elbow
9 Ft. x ( ) = Ft.
Ft.
6” Round,
straight
1 Ft. x ( ) = Ft.
Subtotal column 1 =
Duct pieces To t a l
Equivalent number
length x used =
6” Round
wall cap
with damper
30 Ft. x ( ) = Ft.
Round
wall cap
with damper
30 Ft. x ( ) = Ft.
7” - 10”
Round,
900elbow
15 Ft. x ( ) = Ft.
7” - 10”
7” - 10”
Round,
450elbow
9 Ft. x ( ) = Ft.
Ft.
Ft.
Ft.
6” Round,
roof cap
30 Ft. x ( ) = Ft.
7” - 10”
Round,
roof cap
30 Ft. x ( ) = Ft.
Subtotal column 2 =
Subtotal column 1 =
Total ductwork =
6” round to
3-1/ 4” x 10”
rect.
transition
1 Ft. x ( ) = Ft.
6” round to
3-1/ 4” x 10”
rect.
transition
900elbow
16 Ft. x ( ) = Ft.
7” round to
3 1/ 4” x 10”
rect.
transition
8 Ft. x ( ) = Ft.
7” round to
3-1/ 4” x 10”
rect.
transition
900elbow
23 Ft. x ( ) = Ft.
26” min.
36” max.
36”
side wall cap
w/ gravity damper
side wall cap
w/ gravity damper
Soffit or crawl space
Roof Pitch w/
Flashing & Cap
Top View
3/4 View
Back View
40-
3/8
”, 46-
3/8
”
3”
12”
34-
3/8
”, 40-
3/8
”
2
2
-
1
/2
”
5-
5/8
”
(40”)20-
1/4
”
(46“)23-
1/4
”
C/L
Ø
1
0
”
(40”)15”
(46“)18”
2”
elec.
k/o
C/L
10-3/8”
(40”)15”
(46“)18”
4-
3/8
”
elec.
k/o
Cable Lock
CAUTION: At least two installers are
required due to the weight and size of the
hood.
!
40-
1/2
”
or
4
6-
1/2
”
22-
5/
8
”
cut
ou
t
(AK9340) (AK9346)
1/4”
1-
1/8
”
1
2
11
2
Locking Tabs
Bottom Panel Screws
22
1
Lights On/Dim/Off
5 Min Delay Off
Display (speed level, delay off, filter clean)
Adjust 6 Speed Levels
Blower On/Off
1. Blower On/Off
By pressing the blower is switched on and off. When switched on, the blower starts up on speed level 1.
2. Speed Selection
The 6 speed levels are selected by pressing to decrease and to increase speed levels. The display indicates levels
selected.
3. Delay Off
This feature is used for programmed shut down of blower 5 minutes after the function is activated. Press once, a dot
flashes in the lower right side of display indicating the function is on. The blower will completely shut down after 5
minutes.
4. Lights On/Dim/Off
Switch lights on by pressing once, press a second time to dim and again to shut off lights.
5. Display Window
The display window indicates speed levels and features such as baffle filter clean reminder, delay off and clean air indicator.
Baffle Filter Clean Reminder
Aa set of baffle filters are fitted by the factory, these baffle filters are intended to filter out residue from
cooking. The filters need not be replaced on a regular basis but are required to be kept clean. The Baffle-
Filter Clean reminder function in the microprocessor will automatically indicate by a flashing when the
baffle filters need to be cleaned after every 30 hours of use. Filters can be cleaned by hand with non-
abrasive soap or in a dishwasher. Heavily soiled filters should also be soaked in grease cutting detergent
prior to cleaning.
Baffle Filter Clean Indicator
When flashes on the display, the baffle filters
needo be cleaned. This will occur after every 30
hours of use.
Reset the filter clean reminder timer after filters are
cleaned and re-installed. With hood off, press and
hold for approximately 5 seconds until on
display disappears . The filter clean reminder
function is now reset and a new 30 hours elapse
cycle is initiated.
FClean Filters
display < F > flashes
F
hold 5 sec. display from < F > to < >
To Reset
F
A
hold 5 sec. display from < A > to < >
To Disable
hold 5 sec.
To Enable
F
F
display < A > flashes
A
A 1 A 1
Clean Air Indicator
While Clean Air is active, the display will alternate
between , , , .
After 10 minutes of Clean Air operation, the blower
will power off and the 4 hour timer will reset.
If the blower speed is changed while the Clean Air
Function is in use, the cycle will be interrupted and
the timer will reset after.
Clean Air Function
Clean Air is a feature that turns on the blower on low speed every 4 hours for 10 minutes to remove stagnant
air in the kitchen. The Clean Air function is disabled by default and must be enabled by the user.
Blower On / Speed Selection
Press to power on blower and cycle through all six blower speeds.
Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
Lights On / Dim / Off
Switch lights On by pressing once, again to dim and again to switch Off.
Blower On/
Speed Selection 1
1
2
3
4
Blower On/
Power Off
2
5 Min Delay Off 3Lights On/Dim/Off
4
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the power pack display indicating the
function is on. The blower will change to speed 1 and shut down after 5
minutes.
A
-
+
1
2
11
2
%ORZHU )DQ&XUYH
0RGHO $.0RQVRRQ,,
$&,QSXW 9 +]
2XWOHW'LDPHWHULQ
Model: AK9340AS
w
p
bugyrbrb
THERMALLY PROTECTED
Fan: 633W
Lamp: Max.35Wx2
Total: Max.703W @5.9A
Voltage 120V 60Hz
Power consumption
THERMALLY PROTECTED
Fan: 633W
Lamp: Max.35Wx4
Total: Max.773W @6.5A
Voltage 120V 60Hz
Power consumption
w
p
bugyrbrb
Model: AK9346AS
This manual suits for next models
1
Table of contents
Other Zephyr Ventilation Hood manuals
Zephyr
Zephyr MESA DME-M90ASSX User manual
Zephyr
Zephyr Z1C-00SU User manual
Zephyr
Zephyr ZML-M90BG Installation guide
Zephyr
Zephyr Roma Pro ZRP-E36BS Installation guide
Zephyr
Zephyr Siena ZSI-E30CS User manual
Zephyr
Zephyr Tempest II AK7500ASX Installation guide
Zephyr
Zephyr AK2000 Installation guide
Zephyr
Zephyr ALL-M90BBX Operating and maintenance manual
Zephyr
Zephyr Siena Pro ZSP-E36BS Installation guide
Zephyr
Zephyr Savona Wall Installation guide
Zephyr
Zephyr Tidal I AK7300AS Installation guide
Zephyr
Zephyr Tornado Mini AK8400BS Installation guide
Zephyr
Zephyr Trapeze CTP-E 48SX User manual
Zephyr
Zephyr ZPY-E30AB Installation guide
Zephyr
Zephyr Monsoon DCBL AK9428AS Installation guide
Zephyr
Zephyr Tempest II AK7500ASX Installation guide
Zephyr
Zephyr Roma Island ZRM-E36CS Installation guide
Zephyr
Zephyr Twister AK8000BS Installation guide
Zephyr
Zephyr ACT Siena ZSI-E30BS-ES Installation guide
Zephyr
Zephyr AK6500 series Use Installation guide
Popular Ventilation Hood manuals by other brands
EVE
EVE HF-HSM102AT-60 instruction manual
Omega
Omega K181V90 Instructions for installation and use
Siemens
Siemens LU60LAF24 User manual and installation instructions
Sirius Satellite Radio
Sirius Satellite Radio Stone SU-DD2-L Installation, use and maintenance instructions
Broan
Broan 15000 SERIES instructions
Opera
Opera CLARO Series user manual
Blaupunkt
Blaupunkt 5DD72553 Instructions on mounting an use
Smeg
Smeg KSE912NX instruction manual
Faber
Faber STILO DX/SP A90 instruction manual
Preethi
Preethi KH203 user manual
Bosch
Bosch DWB09W452B Instructions for installation and use
Jenn-Air
Jenn-Air JVR0436H Installation Instructions and Use & Care Guide