Zonet ZEW3002 User manual

All manuals and user guides at all-guides.com
all-guides.com

- 1 -
Package Contents
• One ZEW3002
• One Detachable Antenna
• One CD
• One External AC Power Adapter
• One Quic Installation Guide
If any of the above items is damaged or missing, please contact your local dealer immediately.
Reset the Access Point
1. Power ON ZEW3002
2. Press and hold the reset button for 5 seconds, or until the system LED lits up
3. Release the reset button and wait for 10 seconds for ZEW3002 to reboot
Notice: ZEW3002 must be powered ON before and during reset.
Physical connection of ZEW3002
1. Connect one end of the cable to your broadband router, DSL/Cable modem, PC or Switch/Hub port and connect
the other end to the LAN port of ZEW3002.
2. Power on ZEW3002 by connecting one end of the supplied power adapter to the power jac of ZEW3002 and
connecting the other end to an electrical outlet.
3. Power on your computer.
4. Ma e sure the LEDs of ZEW3002 are lit. If not, try the above steps again.
Note: All devices must be power O b efore physical connection. To achieve maximum wireless coverage, tilt the antenna angel
outward around 45°.
Configure your ZEW3002
Open an Internet Browser and input the ZEW3002 default IP address, username and password as shown
below.
1. Default IP address: http://192.168.0.254
2. Default username and password “admin”
3. Clic on Wizard from the front page
4. Choose your wor ing mode
All manuals and user guides at all-guides.com

- 2 -
5. Setup the Encryption eys for wireless security using the pull-down menu.
6. From LAN Setting Tab, enter the IP address of ZEW3002 (factory default: 192.168.0.254) and subnet mas
(ie: 255.255.255.0).
Notice: Subnet Mask should be identical for all PCs in the same LAN.
7. From Radio Configuration tab, you can configure wireless basic settings.
Please refer to the User Manual for more details on other settings and troubleshooting tips.
All manuals and user guides at all-guides.com