2K Furniture Designs D6501-T User manual

NOTE TO CUSTOMERS:
For ease and speed of assembly we recommend that before you commence each step of the
assembly that you identify all the parts required to complete that step.
We recommend that where possible you allow sufficient space to assemble the item as close
as possible to the place where it will be once assembled.
For the protection of your furniture we recommend that the product is placed on protected
surfaces during assembly to prevent any damage.
During assembly do not over tighten the screws or bolts, as this may damage the product.
Please ensure you retain all the product packaging until the item is completely assembled.
Periodically check all fitting and re-tighten as necessary.
Never allow any liquids to remain on your furniture as absorption can cause the wood to warp
or finish to de-laminate.
It is recommended that this item should be assembled by two adults.
ASSEMBLY INSTRUCTIONS
MODEL # D6501-T DINING TABLE
PAGE 1 OF 3

PAGE 2 OF 3
ASSEMBLY INSTRUCTIONS ITEM # D6501-T DINING TABLE
PARTS IDENTIFICATION
A-
HARDWARE IDENTIFICATION
NOTE: Quantities shown are for one table. Bolts are inches screw threads
Ø5/16”
Ø 5/16”
Ø 5/16”
2”
STEP 1
B- Table Leg
Table Top 1 pc
4 pcs
Hex Bolt 5/16”x2”
1- 8 pcs
2- Lock Washer 5/16” x 22 x 1.2mm 8 pcs
3- Flat Washer 5/16” x 13.5 x 1.8mm 8 pcs
4- Wrench 12.8mm 1 pc
4
1
2
3
B
A

PAGE 3 OF 3
ASSEMBLY INSTRUCTIONS
STEP 2
STEP 3
STEP 4
ITEM # D6501-T DINING TABLE
Unlock
Metal Catches
Flip up apron
Lock
Metal Catches