2K Furniture Designs BK004 User manual

NOTE TO CUSTOMERS:
For ease and speed of assembly we recommend that before you commence each step of the
assembly that you identify all the parts required to complete that step.
We recommend that where possible you allow sufficient space to assemble the item as close
as possible to the place where it will be once assembled.
For the protection of your furniture we recommend that the product is placed on a dry, soft,
smooth and clean surfaces during assembly to prevent any damage. Avoid damp and direct
sunlight.
During assembly do not over tighten the screws or bolts, as this may damage the product.
Please ensure you retain all the product packaging until the item is completely assembled.
Periodically check all fitting and re-tighten as necessary.
Never allow any liquids to remain on your furniture as absorption can cause the wood to warp
or finish to de-laminate.
It is recommended that this item should be assembled by two adults.
MODEL : #BK004 CORNER SHELVING UNIT
PAGE 1 OF 2
All manuals and user guides at all-guides.com

Side Panel Left
Screw m3.5 x 12mm
1 pc
3 pcs
1/2”
Side Panel Right Top & Bottom Panels Shelving Panels
TOOLS REQUIRED
MALLET
1 2
ITEM: #BK004 CORNER SHELVING UNIT
3
24 pcs
PAGE 2 OF 2
STEP 1
P3
H2
1
1 pc
ANTI-TIPPING FITTINGS
Wall Plug
1 pc
H5
Ø9/64”
Anti-Tip strap
1 pc
H6
P3
P4
x10pcs
P2
STEP 2
H1
STEP 3
P1
H2 x14pcs
STEP 4
H5
H6
Mount the Anti-Tip Strap H6
onto the top corner of backside
of side panel by aligning screw H5.
Tie the other end of the Anti-Tip
Strap H6 to a wall by using
screw H4. The wall plug H3 can
be used if the wall is a dry-wall
or a brick wall.
H4
H3
H6
P2
P1
Assemble Anti-Tip Fittings
All manuals and user guides at all-guides.com