2K Furniture Designs B7003-C User manual

NOTE TO CUSTOMERS:
For ease and speed of assembly we recommend that before you commence each step of the
assembly that you identify all the parts required to complete that step.
We recommend that where possible you allow sufficient space to assemble the item as close
as possible to the place where it will be once assembled.
For the protection of your furniture we recommend that the product is placed on protected
surfaces during assembly to prevent any damage.
During assembly do not over tighten the screws or bolts, as this may damage the product.
Please ensure you retain all the product packaging until the item is completely assembled.
Periodically check all fitting and re-tighten as necessary.
Never allow any liquids to remain on your furniture as absorption can cause the wood to warp
or finish to de-laminate.
It is recommended that this item should be assembled by two adults.
ASSEMBLY INSTRUCTIONS
MODEL #B7003-C CHEST
PAGE 1 OF 2

PAGE 2 OF 2
ASSEMBLY INSTRUCTIONS ITEM # B7003-C
PARTS IDENTIFICATION
A- Chest 1 pc
B- Chest Legs
2 pcs Left/2 pcs Right
HARDWARE IDENTIFICATION
1- JCBC Bolt m6 x 60mm 4 pcs
2- Lock Washer 4 pcs
3- Flat Washer 4 pcs
4- Allen Key M4
NOTE: Quantities shown are for one chest . Bolts are metric screw threads
1 pc
Ø 15mm
Ø 18mm
STEP 1
2 3/8”
Ø6mm
4
123
A
B
BB
Left Right
Right
R
E
M
O
V
E
A
L
L
H
A
N
D
L
E
S
A
N
D
R
E
I
N
S
T
A
L
L
T
H
E
H
A
N
D
L
E
S
STEP 2
Box of the legs
and hardware
A

PAGE 1 OF 1
ASSEMBLY INSTRUCTIONS ITEM # B7003-C
FURNITURE TIPPING RESTRAINT
1- Screw m4x 16mm 1 pc
2- Screw m4 x 50mm 1 pc
3- Restraint Strap 1 pc
4- Mounting Bracket
NOTE: Quantities shown are for one server. Bolts are metric screw threads
2 pcs
5/8”
2”
A
1
4
WALL
A
4
2
4
4
3
A
This tip restraint must be attached to a wall stud using the
2” screw enclosed.
1- Attach a bracket securely to the back top of the furniture
using the 5/8” screw provided, through the smaller hole.
2- Locate the other bracket on the wall over a wall stud
and 2 inches below the mounting bracket secured to the
back of your unit. Attach to the wall stud using 2” screw
provided, through the smaller hole.
3- Place the furniture into position so both mounting
brackets are vertically in line.
4- Lace the end of the restraint strap through the larger
hole in each mounting bracket. Bring both ends together
and slide the flat end through the locking end and draw it
through until all slack is removed.
5- Confirm that the strap is securely laced and locked.