IilTEiIDED USE
This laminator is designed for
use with thermal laminating
pouches for laminating paper
or flat paper-like items between
two film layers. It is intended for
home, home ofice or small
office use. ltems not intended
for use with laminator include:
cutency, Social Security cards,
thermal papers, stamps, credit
cards, cards with a magnetic
strip and other similar items.
Also, do not use sharp objects,
unheatrble plastic, historically
valuable papers or
one-of a kind items.
OPEBATII,IG
IIISTBUGTIONS
Place the laminator on a flat,
secure. stable surface.
Plug the power cord into a
standard 120V outlet.
Move the power switch to the "on"
position. Make sure the
red power light is illuminated.
Adjust the Heat Setting switch as
necessary. The 3 mil setting should
be used for laminating standard
printer paper or lighter weight
items. The 5 mil setting should be
used for photo paper, business
cards and other thick items.
Wait for the green ready light to
come on.
Insert the item to be laminated into
a ScotchrM Thermal Laminating
Pouch. so that the borden are even
on all sides. The suggested
minimum border on all sides is
approximately l/8 inch or 3 mm.
(Figure 2, Figure 3)
Adjust input tray guides to the
width of your laminating pouch.
Inse the pouch with the item,
sealed-edge first, straight into the
laminator inlet. Hold the pouch
until the mrchine moves it
forward. (Figure 4)
The laminated item will
automatically exit the outlet of
the laminator Do not pull the
pouch thrcugh the laminator. If
the pouch should becomejammed
or not feed corectly, hold down
thejam release lever and pull the
pouch ftrough the laminator.
Remove pouch after it has
stopped moving and sheet is
cool. (Figure 5)
When finished laminating,
move the power switch to
the "off'position.
Sealed Edoe
f'
(Figure 2)
(Figure 3)
V
-:::I
@^
8.
1.
9.
r0.
3.
4.
-5.
6.
1.
4
lJ< v
@4.
t,lfu
RendeEd on l2/15/2010 l::16:28 PM
