3nStar PTE0905-MSR User manual

i
PTE0905-MSR
UUsseerr''ssMMaannuuaall
Version 1.0

iii
C
Co on nt te en nt ts s
C
Ch ha ap pt te er r 1 1 S Sp pe ec ci if fi ic ca at ti io on ns s 1 1
C
Ch ha ap pt te er r 2 2 M MS SR R I In ns st ta al ll la at ti io on n 2 2
C
Ch ha ap pt te er r 3 3 U Ut ti il li it ty y U Us se er r G Gu ui id de e 3 3
3-1 Utility Setup
3-2 SeIect Interface
3-3 Firmware version
3-4 General setting
3-5 Pre/Postamble
3-6 Track Setting

1
Chapter 1 Specifications
Basic
Information
Unencrypted (Default)
Encrypted
Card Types
Magnetic Cards as per ISO7810, 7811, AAMVA
Read Capability
Magnetic Stripe - Triple Track of Low / High coercivity
Card Handling
Method
Manual Swipe, Bi-Directional
Card Thickness
0.76 ±0.08 mm
LED & Buzzer
Blue/ One Beep
Purple//Two Beep
Red/ Three Beep
N/A
Encryption Type
N/A
Triple DES and AES, DUKPT
Key Management
Power
Requirements
5V
OS Supported
POSready 2009 (32bits), POSready 7 (32 & 64bits), Windows 10
Pro, Windows 10 IoT Enterprise
I/O Interface
Connector Type
USB 2.0 Type A
Interface
USB HID
Dimension
Dimension
(L x W x H)
129.05 x 61.43 x 25.48 mm
Housing Color
Galaxy Gray / Silver

2
Chapter 2 MSR installation
1. Make sure the system is powered off.
2. Remove the right side cover of the PTE0905
3. Install the MSR into USB Type-A Connector of POS, and tighten two screws to
fix the device (see the yellow circle below).
4. Make sure the USB connected and screws are fastened well.
5. Complete installation.

3
Chapter 3 Utility User Guide
3-1 Utility setup
1. Decompress the file: MagSwipe_Cfg_v2.3.5_A.rar
2. Click InstallerPackage
3. Choose setup
4. Click “Next”

4
5. Click “Yes”
6. Click “Yes”
7. Click “Next”

5
8. Click “Next”
9. Click “Next”

6
10. Click “Next”
11. Click Finish (Setup completed)

7
3-2 Select Interface
‧Choose the correct interface
3-3 Firmware Version
‧Click the “Check current reader setting”
1
2

8
3-4 General Setting
1. Change Beeper Behavior/MSR Reading function/Decoding Method, and click
“send to MSR”.
2. Click “OK”
1
2

9
3-5 Pre/Postamble
1. If you want to change your track start/end sentinel, the ISO standard
specification is 7 bits for Track 1, 5 bits for Track 2 and 5 bits for Track 3.
2. There are the settings for prefix and suffix which can be based on your own
preferences, and then click “send to MSR”.

10
3. Click “OK”
3-6 Track Setting
1. The default is “Any Track”, but you can choose the number of tracks what you
need, and then “send to MSR”.

11
2. Click “OK”