ABB FBIP-21 BACnet/IP Installation manual

Safety instructions
WARNING! Obey the safety instructions of the drive. If you ignore them, injury or death, or
damage to the equipment can occur.
Mechanical installation
Electrical installation
Layout of the module
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m
using a Torx TX10 screwdriver.
13
4
WARNING! Do not use excessive force, or leave the screw too loose. Over-tightening can
damage the screw or module. A loose screw decreases the EMC performance, and can
cause an operation failure.
No. Description
1Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1] to Ethernet
4 RJ-45 connector [X2] for chaining another module
5 Diagnostic LEDs
6 MAC address
3
2
5
1
4
6
—
OPTIONS FOR ABB DRIVES
FBIP-21 BACnet/IP adapter module
Quick installation and start-up guide

Start-up
To control the drive with the adapter module, set at least the basic parameters listed in the table
below. For full parameter descriptions, refer to the adapter module’s user manual or to the drive’s
firmware manual.
Basic parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par
refresh.
Connectivity configuration
The FBIP-21 adapter module has a web page for connectivity configuration.
To access the web page:
1. Open a web browser and type the IP address of the adapter module in the address field.
The IP address is visible in group 51, parameters 5...8.
Example: https://192.168.0.24/
2. Log in with a user name and a password.
The default user name: admin
Password: The last six digits of the MAC address of the adapter module, in upper case letters,
without hyphens. The MAC address is visible on the front cover of the adapter module.
Example: If the MAC address of the adapter module is 00-1C-01-00-2F-73, the password is
002F73.
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
51.04 IP configuration Set the IP address according your network configuration.
51.05...08 IP address
51.09 Subnet CIDR
51.14 Device obj ID lo Set a unique device object instance value for BACnet devices.
51.15 Device obj ID hi
See the latest version of FBIP-21 BACnet/IP adapter module
user's manual (3AXD50000028468 [English]) in ABB library
(www.abb.com/drives/documents).
For more information on ABB fieldbus options and protocols,
see the fieldbus communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
FBIP-21 manual
Fieldbus communications web page
© Copyright 2023 ABB. All rights reserved.
Specifications subject to change without notice.
3AXD50000158171 Rev B (EN) 2023-01-25
abb.com/drives