ABB FEPL-02 Ethernet POWERLINK Installation manual

Options for ABB drives, converters and inverters
Quick installation and start-up guide
FEPL-02 Ethernet POWERLINK adapter module
Safety instructions
WARNING! Obey the safety instructions. If you ignore them, injury or death, or damage to the
equipment can occur. See the user’s manual.
Mechanical installation
Electrical installation
Layout of the module
1. Pull out the lock.
2. Install the module carefully to an option
module slot of the drive. See the drive
hardware manual.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m using
a Torx TX10 screwdriver.
WARNING! Do not use excessive force,
or leave the screw too loose. Over-
tightening can damage the screw or
module. A loose screw decreases the EMC
performance, and can even cause an operation
failure.
13
4

No. Description
1Lock
2 Mounting and grounding screw
3 RJ-45 connector [X1]
4 RJ-45 connector [X2]
5 Diagnostic LEDs
6 MAC ID
5
3
2
4
1
6

Connection procedure
1. Connect the network cables to connectors [X1] and [X2] on the module.
2. Connect the cable from the master to the left port [X1].
3. In the line topology, if there are more slave devices in the same line, connect the next slave device to
the right port [X2].
Start-up
When the module is connected to the drive, the drive control program sets the applicable parameters.
See the appropriate drive manual.
Basic parameter settings
To take the settings into use, validate and refresh the parameters with parameter 51.27 FBA par refresh.
Further information
Index Name Value
20.01 Ext1 commands Fieldbus A
22.11 Speed ref1 source FBA A ref 1
28.11 Frequency ref1 source FBA A ref 1
50.01 FBA A enable Enable (or select the option slot in which the module is installed).
This activates the communication module. The HOST LED becomes green.
50.02 FBA A comm loss func Fault
51.02 Profile The CANopen device profile (CiA 402) is the default value.
See the latest version of FEPL-02 Ethernet POWERLINK
adapter module user's manual (3AUA0000123527
[English]) in ABB library (www.abb.com/drives/documents).
For more information on fieldbus options and protocols
provided by ABB Drives, see the fieldbus
communications web page
(new.abb.com/drives/connectivity/fieldbus-connectivity).
3AXD50000158164 Rev A (EN) 2017-11-23
FEPL-02 manual
Fieldbus communications web page