Abbyson P3 User manual

1
To protect you from electric hazards, please read the user manual
very carefully before operating.
Proper use of the product will help extend the lifecycle as well.
1. Please use the original charger to charge for the battery pack. Non-authorized
chargers may damage the product.
2. The specification for the charger is DC 29V 0.8A-2A. Please ensure to use the correct
voltage charger.
3. Avoid putting the battery pack close to heat sources. Avoid using it when the room
temperature is over 100 degrees F.
4. Avoid immersing it in any liquids.
5. Avoid dropping, crushing, throwing, striking and shaking the product.
6. Never inserting anything into the unit.
7. Avoid having the product repaired by unauthorized personnel. Please contact your
place of purchase if it is not working properly.
8. Never operate the unit if it has a damaged cord, power or plug.
9. Never operate the unit if its over-heated or deformed.
10. This product is made for Indoor use only, and please avoid exposure to direct sunlight.
For assistance with assembly or customer service, please contact the Abbyson Customer Experience Team
Toll Free at 1-888-406-0838
www.abbyson.com
ABBYSO
Thank you for your
SAFETY WARNINGS

2
P3 Capacity: 2,200 mAh
P3 (1 battery) Life Cycle Count
1 motor (power feet): Approx. 350 cycles
2 motor (power feet and headrest): Approx. 250 cycles
3 motor (power feet, headrest and lumbar): Approx. 125 cycles
Charging voltage: 29.4VDC / 56.98 Wh
Charging time: Approx. 6 hours
Please note that more powerful reclining furniture with USB, lights, cup
warmers, etc. will dramatically drain the battery faster so you may need
to charge it more often.
Charge Indicator
Press to check
the Power Status

3
• Remove the power supply for the recliner.
• Follow the wiring drawing to connect the battery pack to your recliner.
• Press
for 2 seconds to check the power state of the charge.
1 Light: State of Charge at 25%
2 Lights: State of Charge at 50%
3 Lights: State of Charge at 75%
4 Lights: State of Charge at 100%
When charging, the LED lights flash.
Press for 2 seconds –if the battery begins to buzz after self-inspection, it’s an alert for
low state of charge. Please recharge the battery pack ASAP.

4
ATTENTION
• When the State of Charge is less than 10%, the battery pack will stop automatically.
Please recharge the battery pack to reset it.
• Never disconnect the battery pack when it is discharging.
• The overload protection for the battery pack is 10A. The battery pack will stop
discharging when the load reaches 10A and could not discharge unless you charge the
battery pack to reset it.
• Recharge the battery pack before it runs out to prolong its lifecycle.
• It is recommended not leave the battery pack uncharged for extended periods of time.
• If the battery pack has been in storage for over 3 months, it should be fully recharged
for 6 hours, even if not in use.
• Store the battery pack in a dry and well-ventilated area.
WARRANTY
• The warranty period is 1 year from the date of purchase.
• The warranty is limited to the repair of the faulty device.
• The warranty does not cover any transport or other direct/indirect costs, or any
risks associated with removing/dismounting, transporting, and installing the
products.
• Warranty does not apply due to the following:
• Damage due to incorrect installations or use.
• Damage attributed to utilization not specified in the operating instructions, to
negligence or modification, or to the use of parts that have not been
manufactured.
• Damage caused by accidents, lighting, water, fire, heat, or other events beyond
the control of the retailer.
• Repairs or modifications that have been performed by unauthorized personnel.