Ribbon Cartridge Replacement:
Tear off any paper emerging from the printer.
Open the printer door by pressing the door latch
inwards.
Place forefinger against the lower edge of the
mechanism mounting chassis and thumb
against the base of the door (see Figure 6).
Check that the ribbon cartridge spindle is
correctly seated over the printer ribbon drive
shaft, and snap the cartridge into place.
Ensure that the ribbon is taut and parallel to the
paper.
If necessary tighten the ribbon by turning the
faceted disc clockwise using fingernail (see
Figure 8).
Carefully press the door and chassis in vertically
opposite directions until the catch is released.
Do not pull the door and chassis apart without
first releasing the catch.
Swing the chassis back, leaving the door fully
open. This will expose the printer mechanism
and ink ribbon cartridge.
Press down on the end of the ink ribbon
cartridge marked 'PUSH' (see Figure 7) and
carefully remove the used cartridge.
Fit a replacement cartridge, ensuring that the
paper lies between the ribbon and the steel
printer platen.
If there is some paper protruding from the front
of the printer mechanism, ensure that it will
pass clearly through the guide channel and past
the tear bar before snapping the chassis shut
against the back of the door.
Turn the paper roll by hand so that any loose
turns are wound snugly against the roll.
Close the door and check that the paper flows
freely, using the paper feed button.
Consumables available
A consumables pack (Stock No. A160CBP) is
available containing five 19m rolls of paper and
two Epson ribbon cartridges. Use of this paper
is recommended, as most paper rolls from other
sources are too large to fit within the printer
housing, and may be of inferior quality causing
dust and wear.
ABLE SYSTEMS LIMITED TEL: 01606 48621
DENTON DRIVE, NORTHWICH INTERNATIONAL: +44 606 48621
CHESHIRE CW9 7TU FAX: 01606 44903
GB