ABLE2 SHO-ME 11.1200 User manual

saO-ME@
MODEL NO.11.1200
Permanent Mount Low Profile
LED Mini Bar
GENERAL INFORMATION:
The saG-ME @Low Profile LED Mini Bar is equippedwith a Solid State Flasher. The flasher has
7 flash patterns including random.Tochange flash patterns momentarily apply+12vto the white, mode wire.
Each time +12v isapplied, the flash patternwill change.
FLASH PATTERNS
DoubleAlternating
QuadAlternating
QuintAlternating
MegaAlternating
Double Simultaneous
Quad Simultaneous
Random
INSTALLATION INSTRUCTIONS:
Determine location to mount your Low Profile LED Mini Light Bar. Do not installthis product or route any wires in the
deployment area ofyour air bag. Equipment mounted or located in the air bag deployment area will damage or reduce the
effectiveness of the air bag, or becomea projectilethat could cause serious personal injury or death. Referto your vehicle
owners manualfor the air bagdeployment area. The User/Installer assumes full responsibilityto determine proper
mounting location, based on providing ultimate safety to all passengers insidethe vehicle.
WARNING: The steel content ofvehicle roofsvaries considerably and some maynot be suitablefor mountingwarning
lightswith magnetic bases. It is the sole responsibility of the users of magnetic based lightsto determine if portable
warning lights may be safely used onthe exterior of their vehicle.
If mountingthis product requires drilling holes, the installer MUST be sure that novehicle components or other vital
partscould be damaged bythe drilling process. Check both sides of the mounting surface before drilling begins. Also de-
burrany holes and remove any metal shards or remnants. Installgrommets intoallwire passage holes.
Useonly soap and water to clean the outer lens. Useof other chemicals could result in premature lens cracking
(crazing)and discoloration. Lensesinthis condition have significantlyreduced effectiveness. Inspectand operate this
product regularlyto confirm its proper operation and mounting condition. Do not use a pressurewasher to clean this
product. PRODUCTS COMPANY. 804 East Hwy. 248 .Cassvllle,MO65625
U.S. and Canada Toll Free Numbers. Phone: [phone] FAX: [phone]
E-mail: sa/[email protected] WEB: www.able2products.com 11,00

12
14
2
"-.J~~~/ /
T /
7
...~
T "
.
.'. ./
'-"
T .'.
'-',.
-/ l
/ "',.
'.", '.
13
4
6-7
I
I
i~ ~
I\~~
i
:22
,
.,'f'
i
. i
,.,.,+,.,., ~
i.'. .
'
j'J
! 'J
.".J
~Cf
4
13
/20
~
LIMITED WARRANTY
Parts Listfor 11.1200.000
Low Profile LED Mini Bar Permanent
ITEM MODEL NO.
1 90.4986.000
2 90.6127.COO
3 90.6125.000
4 90.6938.000
5 90.6931.000
6 90.3750.(R/A)00
7 90.3751.BOO
8 90.4958.000
9 90.4522.000
10 90.4081.000
11 90.4150.000
12 90.4002.000
13 90.4072.000
14 90.4002
15 90.4021.SS
16 90.6880.000
17 41.0181.010
18 90.6039.000
19 11.1005.TSF
20 44.0183.000
21 61.0651.000
22 90.6773.000
OTY
1
1
2
2
2
DESCRIPTION
MainAlu Extrusion
Clear Lexan Cover
Black Plastic Endcaps
Long Black PlasticLED mount
Short Black PlasticLED mount
Red/Amber LED Board
Blue LED Board
Brkts/Stealth 15GA SS 2
MountingWasher 8
y. -20 X Y:zHex Hd Bolt SS 4
Mount Nylon Insert Nut 4
#8 X Y:z812 SelfTapping Screw 9
Small BlackScrew 10
10MMWide Head Screw 4
EndcapSelfTapping Screws 4
Gromet 1
18 GA RVI Wire 15" (specify color) 6
y""X %" Black FoamAdhesive 50" 1
Solid State Random LED Flasher 1
PowerCable4 Wire 12ft 1
7" CableTies 5
EndcapGasket 2
Able 2 Products Company warrants each new product (except bulbs and strobe tubes) to be free from defects in material
and workmanship for a period of two years from the date of purchase. During this warranty period, the obligation of Able 2 is
limited to repairing or replacing, as Able 2 may elect, any part or parts, which after examination by Able 2 are determined to be
defective, when they are delivered pre-paid. This limited warranty does not cover travel expense, the cost of specialized equip-
ment for gaining access to the product, or labor charges for the removal and re-installation of the product.
Able 2 Products Company shall not be liable for incidental or consequential damages, including but not limited to: Loss of
use of vehicle, Rental of substitute vehicle, Loss of time, Loss of work, Inconvenience, Transportation expenses, Telephone,
Lodging, Loss of revenue, Loss of and/or damage to personal property for or arising out of breach of any express or implied
warranty of its products.
Use of lamp or other electrical load of a wattage higher than installed or recommended by the factory, or use of inappro-
priate or inadequate wiring or circuit protection causes this limited warranty to become void. Able 2 Products Company will in no
way be liable for any loss of profits or any indirect or consequential damages arising out of any such defect in material and
workmanship whether loss is due to negligence or breach of warranty. This limited warranty does not apply to shipping damage,
accident, alteration, tampering, misuse or abuse and unauthorized service.
This limited warranty is expressly in lieu of all other express or implied warranties, including the implied warranty of
merchantability and the implied warranty of fitness for a particular purpose, and of all other obligations or liabilities on the part of
Able 2 Products Company. There are no warranties, unless expressed in authorized Able 2 literature, which extend beyond the
description of the face hereof. No dealer, distributor, employee, or representative of the company is authorized to change this
warranty in any way or to grant any other warranty.
PRODUCT RETURNS
If a product must be returned, contact our factory by calling 1-800-641-4098 to obtain a Return Authorization Number
(RA) before you ship the product. Write the RA Number clearly on the package and return it to Able 2 Products Company, P.O.
Box 543, 804 E. Hwy. 248, Cassville, MO 65625-0543. A packing slip should be included with all shipments listing the sender's
name, address, daytime phone number and description of defect. Your product will be put in first-class operating condition or
replaced with a new part. and returned pre-paid.