Access Lighting NITRO 2 62293 User manual

IMPORTANT
Before assembling your access lighting fixture, please make sure that
you carefully read through these instruction sheets. Consider having
your fixture installed by a qualified licensed electrician.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and
care, are factors that can’t be built into any product. These factors must
be supplied by the person(s) caring for and operating the fixture.
STEP BY STEP INSTRUCTIONS
Before starting your installation disconnect the Power by turning off the
Circuit Breaker or by removing the fuse at the fuse box. Just turning the
light off at the light switch is not sufficient to prevent electrical shock.
PREPARE FIXTURE
If there is an existing fixture remove it.
Expose the supply wire from the J-box.
1
GENERAL INFORMATION
All electrical connections must be in accordance with all ordinances,
Local and National Electrical Codes. These fixtures are intended for
mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box
must be directly supported by the building structure and U.L. Recognized.
WHAT YOU NEED
• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
INSTALLATION INSTRUCTIONS
WHAT WE PROVIDE
• Mounting Hardware
• Crossbar Plate
• 3 x Glass shades
• 3 x 100W J78
COLLECTION
1
CERTIFICATION: cETL DAMP NO. 62293
62293
APPLICATION MODEL NO.
Wall Fixture
NITRO 2

2
4
2
CERTIFICATION: cETL DAMP NO. 62293
3
MOUNT CROSSBAR PLATE
Gently pull the supply wires out of the J-box.
Mount the crossbar to the J-box with the supplied
screws.
MAKE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white
fixture wire. Secure with the supplied wire nuts. Either
wrap the green wire around one of the protruding screws
or connect it to the supply ground wire. Secure all wire
with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT FIXTURE TO THE CROSSBAR PLATE
Position the fixture plate over the crossbar plate.
Align the holes at the top and bottom of the plate.
Secure with the supplied screws.

WHAT YOU NEED
• Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
3
CERTIFICATION: cETL DAMP
NO. 62293
5
7
INSERT THE BULBS
Insert the supplied bulbs.
MAXIMUM WATTAGE 100W.
DO NOT EXCEED THE WATTAGE AS STATED
ON THE WARNING LABEL AND IN THE INSTRUCTION
SHEETS
SECURE THE GLASS SHADES
Insert the bulb covers and slide the glass shades into
the metal grooves.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs thatmight exceed the
maximum wattage, stated on cautionlabel.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS FIXTURE
6