Acclaim Lighting TC-1 U User manual

TC-1 E/U
USER’S MANUAL
F
D
24-004-3040-00
Rev1.0
US VERSION

GENERAL INFORMATION
You made the right decision by choosing this compact and easily operation dimmer unit. Every unit has been thoroughly tested and
carefully packed before shipment. Unpack the shipping carton carefully, saving the carton and all packing materials for possible later use.
Check carefully for sure your product is not damaged and all accessories not missing. If your product appears to be damaged or missing,
please do not use it and contact your local distributor immediately.
Please read this manual carefully and thoroughly, as it gives important information regarding safety, use and maintenance. Keep this
manual with the unit for possible future reference.
PRODUCT FEATURES
TECHNICAL SPECIFICATION
Power Requirement
Power Output
Power Consumption
Drive Current
Control
IP Rating
Fuse
Physical Dimensions
Weight
DC12-24V
DC12-24V
2.4W max
200mA
DMX512
IP20
200mA
80(L) X 124(W) X 41(H) mm(US)
85(L) X 85(W) X 41(H) mm(EU)
120g(EU)/95g(US)
512 DMX Output, all channels can be controlled by a touching fader
Infrared remote control function available
Up to 10 years storage in memory for data
Only for indoor use
0-10V Analog signal output, 3 mA max
-1-

OPERATION GUIDE
Connect the device to a proper power outlet and poweron this unit, then the TC-1 is ready for use.
1. Power button
Tap the Power button to turn on the output while this unit is in standby status, the output
will change to the desired value gradually as per the fadetime set.
Tap the Power button to turn off the output while this unit is on, the output will change
to zero gradually as per the fadetime set.
Keep pressing the Power Button for 10s, this will allow users to change the way to power
ON/OFF this unit. Users can make it instant effort or 5s delay, when user select the instant
effort, the device will response promptly(ON/OFF) when user tap the power button,
while it will be effective after 5s when user select the 5s delay.
2. Fadetime Button
Tap the F button, the corresponding indicator will light up, indicating that this device is
engaged in fadetime adjusting mode,users are allowed to set the fadetime via the fader
within the range of 0.01s to 10s.
Tap the D button, the Dimmer indicator will light up, indicating that this unit is engaged in
Dimmer adjusting mode,
Tap the fader upwards and downwards to set the Dimmer value within the range of 0%-100%.
-2-

IR Control
FA D E
D I M
TC1
Before operating the device via the IR control, please fill the IR controller with CR2025 battery. Refer to the
following table for relevant functions.
Button Function
POWER
DIM-
DIM+
FADE-
FADE+
INTENSITY
To power on/off
Decrease the output intensity
Increase the output intensity
Decrease the fadetime, min=0.01s
Increase the fadetime, max=10s
Keep pressing the key until the intensity
change to corresponding level
-3-