ActionTec MegaPlug AV User manual

Note: An Ethernet port looks similar to a phone port but is slightly larger.
1
Connect the Adapter to a PC or Modem/Router
Step1Get one MegaPlug AV
200 Mbps Ethernet Adapter from
the box.
Step5Plug the other end of the
Ethernet Cable into an OPEN
Ethernet Port on your Modem or
Router.
Step4Plug the MegaPlug
Adapter into a Power Outlet.
Do NOT plug the Adapter into a
power strip or wall outlet that uses
surge protection as the Adapter
may not work.
Flip this Quick Start Guide over to continue NE T
Step2Get one Ethernet Cable.
Step3Plug one end of the
Ethernet Cable into the Ethernet
Port on the bottom of the
MegaPlug Adapter.
Step6Repeat Steps 1-5 for a
computer or an Internet device.
Questions? Call 1-888-436-0657 (USA) Questions? Call 1-888-436-0657 (USA)
Broadband
Router

Quick Start Guide
Connect the Adapter to a PC
or Modem/Router
1
This Quick Start Guide will walk you through the
easy steps to install your MegaPlug™ AV 200 Mbps
Ethernet Adapters.
ou will need the following items:
•Two MegaPlug™ AV 200 Mbps
Ethernet Adapters
•Two Ethernet Cables
NE T
Questions? Call 1-888-436-0657 (USA)
Model# HPE200AVP
Step7Make sure that the Link
light on each Adapter turns
SOLID Green.
Congratulations! ou have successfully installed both MegaPlug
AV 200 Mbps Ethernet Adapters.
These adapters ship with a generic encryption key. If you would
like to change the key,refer to our website for further instructions.
If you require additional adapters for additonal computers/devices,
they may be added by following the same steps in this guide.
Part No: 0530-0553-003 QS841/0806
www.actiontec.com/howto