ADAPT SOLUTIONS HI-LIFT User manual

1
HI-LIFT

2
USER GUIDE
To load your wheelchair
The HI-LIFT is an optional wheelchair lift designed to lift manual rigid or folding wheelchair into your minivan via the sliding
door.
Follow the next few steps:
Once you have transferred out of your wheelchair, open the sliding door of your minivan to gain access to your HI-
LIFT. Retrieve your hand held pendant.
Press and hold the OUT button until the HI-LIFT has completely pivoted out of your vehicle.
Press and hold the DOWN button until the strap of the HI-LIFT has lowered enough to reach the seat of your
wheelchair. Remove your cushion and hook the strap to the loop that has been installed under the cushion of your
wheelchair.

3
USER GUIDE (CONTINUED)
To load your wheelchair
Press and hold the UP button until your wheelchair is high enough to enter the vehicle. When you release the button,
the HI-LIFT will stop moving. Press and hold the IN button until your wheelchair is completely inside the vehicle. For this
motion to go smoothly, we strongly suggest you keep a hand on your wheelchair (as pictured below) to help guide
the chair into place. This will also prevent your wheelchair from sliding from side to side. Press and hold the DOWN
button until your wheelchair touches the floor inside your vehicle. We suggest you then fasten your wheelchair in
place.
Stow the hand held pendant and close the vehicle’s sliding door.
WARNING
WHEN OPERATING THE HI-LIFT, ALWAYS KEEP A HAND ON THE WHEELCHAIR TO
PREVENT IT FROM SWINGING FROM SIDE TO SIDE.
WARNING: This product can expose you to chemicals including benzene, which is known to the State of California to
cause cancer and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

4
USER GUIDE (CONTINUED)
To unload your wheelchair
Follow the next few steps:
Open the sliding door and retrieve the hand held pendant.
Once you have unfastened your wheelchair, press and hold the UP button until your wheelchair has lifted off the
floor of the vehicle enough to clear the doorsill. Press and hold the OUT button until your wheelchair has come
completely out of your vehicle. For this motion to go smoothly, we strongly suggest you keep a hand on your
wheelchair (as pictured below) to help guide the chair out of the vehicle. This will also prevent your wheelchair from
sliding from side to side. Press and hold the DOWN button until your wheelchairs has completely lowered to the
ground.
Unhook the HI-LIFT strap from your wheelchair. Press and hold the ‘UP’ button until the strap of the HI-LIFT is fully
stowed. Then, press and hold the IN button until the HI-LIFT has pivoted into the vehicle. Replace the pendant and
close the door.

5

6
3 YEAR LIMITED WARRANTY
HI-LIFT
Adapt Solutions # 1 Ltd. (Adapt Solutions), warrants to the original purchaser of a HI-LIFT that the equipment is free from
defects in material and workmanship for a period of three years from date of purchase.
During the first year of the warranty, Adapt Solutions will supply the replacement parts as well as a pre-set monetary amount
(determined by Adapt Solutions) for the repair if a defect in materiel or workmanship is discovered. After the initial year of
this warranty, only parts and components are covered. This warranty does not cover labour and other services after the
initial year. Freight and other related repair charges will be the responsibility of the original purchaser.
The only remedy for a defect in one of Adapt Solutions products shall be the repair or the replacement, at the discretion
of Adapt Solutions, of the defective part or component. If repair or replacement is not commercially practical or cannot
be timely made, Adapt Solutions may decide to refund the purchase price of the equipment instead of repairing or
replacing the original equipment.
In no event shall Adapt Solutions be responsible for indirect, incidental or consequential damages, whether such damages
arise from claims based on contract, warranty, tort (including negligence), strict liability or product liability.
All implied warranties, including any warranty of merchantability or fitness for a particular purpose, are limited in their
duration to the length of the warranty stated above for the affected component.
This warranty is to the original purchaser only, and excludes product damage due to installation error, product misuse,
product abuse, accidents, physical damage, damage in shipment, modifications not made by Adapt Solutions, or repairs
undertaken by anyone other than authorized distributors.

7
TO OBTAIN WARRANTY PARTS OR REIMBURSEMENT
You must follow these procedures:
1. Obtain warranty authorization by calling your local Adapt Solutions dealer or Adapt Solutions directly at 1-866-641-
0419.
2. Return the faulty Adapt Solutions component/equipment, freight prepaid, to the address provided by your Adapt
Solutions dealer or Adapt Solutions with proof of purchase indicating the date purchased.
Adapt Solutions will pay for shipping back to the purchaser within the continental United States and Canada if a defect in
materiel or workmanship is discovered. Return freight and repair charges will be the responsibility of the purchaser if the
problem is not covered by warranty.
This warranty gives you specific legal rights, and you may also have other rights that vary from state to state/ province to
province. Adapt Solutions specifically does not authorize any person to extend the time or scope of this warranty.
For further information regarding this limited warranty, please contact us by calling 1-866-641-0419 or by writing at the
following address:
Adapt Solutions / Warranty Department
145 Damase-Breton
St-Lambert-de-Lauzon, Québec
G0S 2W0 Canada

8
WARRANTY REGISTRATION
Adapt Solutions #1 Ltd located in St-Lambert-de-Lauzon, Québec, Canada, warrants this product to be free from any
manufacturer’s defect and workmanship for a period of three years from the date of purchase. This product has to be
installed by an authorized dealer and has to be operated properly to be warranted. This warranty is limited to the original
purchaser and does not cover defects on the vehicle. The warranty registration must be completed and returned within
30 days of purchase. This warranty does not cover abnormal wear or damages resulting from an accident, misuse,
neglect of if the product has been altered in any way or aspect. Defective parts must be returned by an authorised
dealer, who will have received a prior return authorization from Adapt Solutions #1 Ltd. All warranted parts shall be sent
to Adapt Solutions #1 Ltd prepaid. Parts will be replaced or repaired at Adapt Solutions #1 Ltd.
Date installed:______________________________________
Dealer:_____________________________________________
Dealer signature:____________________________________
TO KEEP FOR YOUR RECORDS
(Place serial number here)