Adax VP11 Series User manual

4
3
2
1
Electric installation in bathrooms
must be carried out by an authorised electrician.
Installation instructions
220-240 Volt ~ , IP 20, Class II print # 62232
081112
1
22= Neutral = Blue
1= Live = Brown
Permanent electric installation
must be carried out by an authorised electrician
200
200
300
300
300
600
600
A370
430
540
660
730
950
1175
L
500
750
1000
1250
1500
2000
2500
Watt
VP11 T/tim

Oil fumes,
max. 5 min.
The overheating
cut-out resets
automatically
Clean every month during period of use
If room temperature
and thermostat
setting deviate:
230 V ~
IP20
1 3
Calibrate by
holding the
scale while
turning the
knob
4 5 6
Instructions for use
220-240 Volt ~ , IP 20, Class II
The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Please note that
this symbol means
“Do not cover”.
2
Actuators,
position ON
Actuators,
position OFF
Switch
0 = Off
The heater is switched off all
the time
I = On
The heater is switched on all
the time and the temperature
is regulated by the thermostat.
= Automatic
The heater is switched on and
off by the timer. When it is
switched on, the temperature
is regulated by the thermostat.
When the heater is switched
off, no heat is provided and
the temperature depends on
conditions in the room and
the outside temperature which
may sink to below zero; i.e.
there is no safeguard against
frost.
Programming (automatic)
The outer ring on the timer consists of switch actuators
that can be pushed in and out. Each actuator represents
a period of 15 minutes. When an actuator is pressed
away from the centre of the circle, the heater will be
switched on and will work according to the thermostat
setting for this 15 minute period.
A short warm-up period is necessary from the time
when the heater is switched on until the desired room
temperature is reached, depending on the size of the
room, insulation, etc.
Experience will show how long a warm-up period is
required. A typical example may be having the actuators
pushed to the on position from 6.00 to 8.30 and from
16.00 to 23.00, as illustrated.
To set the correct time
Set the timer to the correct time by turning the outer
ring of actuators so that the correct hour is adjacent to
the arrow (the illustration shows the timer set to 21.00,
i.e. 9 p.m.)
print # 62232
081112
VP11 T/tim