ADT Video Doorbell
Quick Installation Guide INTRODUCTION
5
DBC845 Wireless Doorbell Camera Installation
Overview
Doorbell/WPS Button has two functions:
WPS Pin Code Mode: When pressed and held 5 seconds, the doorbell camera will
be in WPS Pin Code Mode.
Note: When Wi-Fi connection is established, the WPS function is disabled.
Doorbell Mode: Press the button to ring the door chime.
LED Activity & Behavior:
Doorbell Activity
LED Color LED
Intensity
LED
Behavior Description
Power Up ADT Blue Medium Solid
WPS Mode Green Medium Blinking Time out 2 mins
WPS Failure Red Medium Solid for 5
seconds
When WPS pair fails, RED LED solid on fr
5s. Then return back to Network
disconnection behavior till someone
Network
Connected ADT Blue Medium Solid
After connected to network, then LED
goes into Standby mode and related
LED behavior while working mode is
Network
Disconnection Red Medium Blinking This priority Is higer than Network
Standby mode
A/C Disconnected
(or other external
power resource
in the future.)
Red Medium
Blinking in
2s
LED will blink red with 2 second when
wired and A/C is not detected
At this moment, if the network is
connected, the ADT blue is solid, then
red LED is edges blinking and then after
ADT blue 10s edges m.
* When Battery pack replaces AC cable
in the feature, this LED behavior will
present Battery pack connection status.
ALL NA OFF
This priority Is higer than Network
connected.
Standby to PIR
trigger ADT Blue Dim ON After PIR trigger without button press.
Doorbell Button
Pressed ADT Blue Off-Dim-
High
Pulsing for
10 seconds
LED will pulse between OFF(1s) -> dim -
> High(1s) intensity while the session is
set up. Then return back to Network
connection behavior till Doorbell run
