ADTRAN NetVanta Analog Modem Dial Backup Interface... User manual

NETVANTA ANALOG MODEM DIAL BACKUP INTERFACE MODULE (DIM) P/N 1200864L1
For more detailed documentation, visit us online at www.adtran.com
Quick Start Guide
Quick Start Guide, 61200864L1-13B, February 2004 Technical Support 1-888-4ADTRAN (1-888-423-8726) 2004 ADTRAN, All Rights Reserved
SPECIFICATIONS
• ITU V.90 Compliant
• Async
INSTALLATION INSTRUCTIONS
1. Remove power from the base unit.
2. If the Network Interface Module (NIM) is already in the
NetVanta chassis, release the pins at both edges of the
NIM faceplate and slide the module out of the chassis.
3. Carefully align the P1 connector on the NIM with the J1
connector on the analog modem DIM. Using only
fingertip pressure so that neither circuit board bends or
flexes, ensure that the connectors are firmly seated.
Secure the analog modem DIM to the NIM using the
screws and standoff posts supplied.
12 VDC
POWER
CONSOLE
LAN
SLOT 1 NET/D BU
WAN-DDS DBU
WAN-DDS DBU
4. Slide the NIM with the analog modem DIM attached
into the NetVanta option slot until the NIM is firmly
seated against the back of the chassis.
5. Secure the pins at both edges of the NIM.
6. Connect the cables to the associated device(s).
7. Complete installation of the base unit.
8. Restore power to the base unit.
ANALOG MODEM DBU (RJ-48C) CONNECTION PINOUT
Pin Name Description
1-3 — Unused
4 R Network-Ring
5 T Network-Tip
6-8 — Unused
INSTALLATION INSTRUCTIONS (CONTINUED)

NETVANTA ANALOG MODEM DIAL BACKUP INTERFACE MODULE (DIM) P/N 1200864L1
For more detailed documentation, visit us online at www.adtran.com
Quick Start Guide
Quick Start Guide, 61200864L1-13B, February 2004 Technical Support 1-888-4ADTRAN (1-888-423-8726) 2004 ADTRAN, All Rights Reserved
alias <text>
Comment line to provide the text name assigned by the SNMP network management system.
caller-id override always <number>
Forces a replacement of the incoming caller ID number with the number given. The received
caller ID, if any, is discarded, and the given override number is used to connect the incoming
call to a circuit of the same number. Use no caller-id override (default) to disable any caller
ID overrides.
caller-id override if-no-CID <number>
Allows a replacement of the received caller ID number, but only if there is no caller ID
available on the incoming call. The received caller ID, if available, is used to connect the call.
However, if no caller ID is received, the given override number is used to connect the
incoming call to a circuit of the same number.
description <text>
Comment line to provide an identifier for this interface (for example, circuit ID, contact
information, etc.).
dialin
Enables the modem for remote console dialin disabling the use of the modem for dial-backup.
shutdown
Turns off the unit. The no version of this command turns the interface on and allows it to pass
data.
ANALOG MODEM DIAL BACKUP DIM COMMANDS