FORM NO. 56091082 - Advolution 24B, 24BT - 7
PREPARING THE MACHINE
FOR USE
(B)-INSTALLING THE BATTERIES
1Carefully lift the batteries into the battery tray. Arrange as shown in
Figure B.
B
2Make sure the key switch is in the OFF position.
3Install the battery cables as shown in figure B, with the terminals marked
“P” on the positive battery posts and the terminals marked “N” on the
negative battery posts. Position the cables so that the caps can be
easily removed when it is necessary to add water to the batteries.
4Tighten the nut on each battery terminal just enough to keep the terminal
from being turned on the battery post. Then tighten the nut one more
full turn.
5Coat all the terminals and posts with grease, petroleum jelly or spray-on
battery coating (available at most auto parts stores).
6Put on the black rubber “boots” over each of the terminals and use the
plastic tie straps to hold them in place.
7Join the connector from the battery pack to the connector on the control
panel.
8Reassemble machine.
NOTE: Charge the batteries before using the machine.
(C)-PAD INSTALLATION
Your local Nilfisk-Advance distributor can provide the proper pads and floor
finishes for use with this machine.
CAUTION!
Using the wrong kind of pad on this machine can damage
the floor. The pad must be centered properly on the pad
holder to prevent machine vibration.
For pad installation, follow the steps below (see steps 1 - 6 in Figure
C):
1 Turn the key switch off.
2Put the machine in the position shown, to access the pad retainer.
3 Goto the front ofthe machine. Whileholdingthepad retainer with onehand,
rotate the pad and pad driver counter clockwise to loosen the pad retainer.
4 Remove the old pad and install a new one, being careful to center it on
the outside diameter of the pad driver. NOTE: Vibration could occur if you
center the hole in the pad to the opening for the pad retainer. Always
use a high quality pad rated to operate at 2000 rpm.
5 Retighten the pad retainer as tight as possible.
6 Raise the back of the machine to lower the pad housing by lifting as
shown.
(D)-DUST BAG INSTALLATION
Your local Nilfisk-Advance distributor can provide the proper pads and floor
finishes for use with this machine.
IMPORTANT!
Install dust collector bag on top of control housing (see Figure
D). The dust collection system will not operate properly if the
collector bag is full or torn.
(E)-ADJUSTING PAD PRESSURE
The pad pressure is set at the factory for optimal burnishing with most
pad and finish combinations. If unique pad or finish conditions require
pad pressure adjustments, adjust by following the procedure below.
NOTE: Pad pressure adjustments should be performed by a qualified
service technician.
1Turn key switch off (O).
2From underneath burnisher, loosen jam nut (A).
3 To decrease pad pressure , turn bolt (B) clockwise.
4 To increase pad pressure, turn bolt (B) counterclockwise.
5 Re-tighten jam nut (A).
EN
ENGLISH
